It started as a whining sound when I turn left then developed into a braking problem when turning (feels like trying to stop on ice). When I pull the fuse ABS control module fuse (#6 under the in the under hood fuse and relay center), the whining and brake issues go away.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
The 2001 Oldsmobile Alero has 119 complaints for turns over but won't start. ...Achieva · Aurora · Bravada · Calais · Cutlass · Cutlass Calais · Cutlass Ciera · Cutlass... We try giving it a jump, still does not start. .... oil sludge whining noise stalls while driving engine complaint electrical issue .... Mom my car wont start AGAIN.
Long story short the car will now start and idle when you step on the gas it will rev ....This whining noise seems to start when the engine temp goes above 200 degrees. ...hood from the outside on an 1999 oldsmobile aurora when i cant get in my car. .... My2001 Oldsmobile Aurora has had the battery disconnected due to a ...
Is the engine turning over with the key in the start position? If the engine is not spinning over and you hear a whining noise, the starter is not engaging the flywheel. If the engine is turning over with the starter engaged, the engine has most likely jumped time that creates low or no compression which results in the whining noise.
It sounds like a belt thats slipping. You have a sticking puley somewhere, take off the belt and rotate all of the pulleys. Usually its an AC compressor pulley so pay special attention to it. The whining noise that it makes while turning, is it the same as the squealing noise? If so it could be a problem with the pump, check the fluid level and see if its an odd color or has an odd odor (like burnt or black). Hope this helps!
Sounds like a wheel hub assembly is bad without seeing it. Alot of GM vehicles have the ABS wheel speed sensors built into the hub assemblies. Should be able to narrow the noise down by driving the car slightly turn left and right noise should change from loud to soft when turning the wheel. ( if you turn left and noise gets louder hub on right front is noisey.Opposite will occur if left side is bad)
AWD disabled from a sensor unit in rear differential that senses high temp. This thing is over $300. Whine is from fluid. Need to change fluid. This versatrack fluid is about $40 per bottle and you need 3 bottles. Thumping noise is from loose rear knuckle bushings. These are part of the entire rear knuckle assy. and you must replace complete knuckle.
Check the condition of front disc brake pads, if they are in need of replacement a preset little metal arm starts rubbing the discs and will make a whining noise. It doesn't do any damage but it's irritating to listen to.