Question about 2000 Chevrolet S-10

1 Answer

2000s10 my 2000 s10 runs good without massflow sencer will it hurt any thing

Posted by on

  • 2 more comments 
  • mcale Mar 08, 2009

    is that my problem or what

  • mcale Mar 08, 2009

    my truck going down inter state started running bad then stoped running i took off maf it started and ran good i have had problems with cold start if i didnt let it warm up for 10 min it would back fire and stall out i would have to fast idel it for a min or two an d it would run better but not right i took it mounts ogo to try it and my truck would burn some rubber but trans shifted hard i had it tested test showed maf was bad got new one drove it for hour no help retested it it said maf still bad so ot 200.00 i got my money back if i had my way i would take all that bs off un nessery **** .this is the worst running truck i ever owned and parts prices ****

  • mcale Mar 08, 2009

    i took it to gm dealer to re boot comp i hour later they said comp was ok aap sencer was plugged charged me 100/00 that i cant aford also dis cap problems water in distribiter cap cost 80.00 gm is makeing killing on parts i would sell it but cant i disabled no money so stuck with it

  • mcale Mar 08, 2009

    any body help thanks



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 281 Answers

Your Cadillac converter.

Posted on Mar 08, 2009

  • Matthew Albert
    Matthew Albert Mar 08, 2009

    I would recommend keeping the MAF plugged in,

    What problems are you having?



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Plugs, destributer, destibuter cap,wires, map sensor replaced. still not running right

check the raideator temp sencer and massflow sencer get a diagnosticreading done and work from that

Jan 24, 2013 | 1994 Cadillac DeVille

1 Answer

I have an 02 s10 it has been having a code for #2 o2 sencer heater not working could this be my problem?

the O2 sensor heater circuit is just what it says it is a heater fo the O2 sensor, it is there to make sure the sensor stays a constant temperature, the sensors like a lot of heat, if the heater is not working the sensor will not give proper info. about the amount of O2 ( oxygen ) in the exhaust flow which could cause the engine to run to rich or lean in either case the engine will not perform as good as it should and can cost you fuel mileage, it the worst case sanario the heater can short to the sensor return wire and cause all kinds of bad things to happen like cook the ECM, i suggest you replace the sensor, the #2 sensor will be the one after the catholic converter.

Mar 15, 2011 | 2005 Chevrolet Suburban

2 Answers

84 chevy s10 trany

no not realey but it would be good idear to re place it . ok

May 03, 2009 | 1984 Chevrolet S-10

1 Answer

I dont under stand why my truck will only run and

Wow, that's a new one on me. They usually won't run without those plugged in. I got 3 words for ya, Good Luck Buddy. But until then, I would leave them unplugged and drive it. It will most definetly use more gas, but at least it will run.

Apr 26, 2009 | 1993 Ford Ranger SuperCab

1 Answer

2003 S10 4.3 litre

check coolant temp sencer for ecm check for ecm p codes

Apr 04, 2009 | 2003 Chevrolet S-10

2 Answers

84 s10 catalytic converter

just plug the air tube if you don't need it. it won't hurt a thing

Feb 19, 2009 | 1984 Chevrolet S-10

2 Answers

1994 F150 Ford

could be a tps sensor or map sensor. have truck scanned for exact codes

Oct 07, 2008 | 1994 Ford F150 Styleside Supercab

1 Answer

Removing a cat converter on a 1998 s10 blazer 4.3

You can safely remove the convertor as you asked but depending on your location your vehicle may not pass a safety or emissions inspection.

Sep 13, 2008 | 1998 Chevrolet Blazer

Not finding what you are looking for?
2000 Chevrolet S-10 Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides