Question about 1992 Mitsubishi 3000GT

1 Answer

The two center spark plugs are dead on a 1992 stealth

The coilpacks have been changed and plug wires but it still has the same problems and the check engion light is on can any one tell me how to check it? id think the problem whould be the ecu or the crank position sencer but how whould i find out whith one?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,066 Answers

Sounds like a bad ground or a bad connection someplace.

Posted on Mar 08, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

P0300 CODE


check spark at the coil is ok .you need a spark plug tester.then remove the leads plug in the tester. turn the engine over are you getting a spark if no .check the distributor cap .clean the contacts,check the bush in the center is ok. check and clean your rotor arm..now check the plugs ,smell them if smell of fuel and no spark change them.

Dec 21, 2013 | 2006 Saturn ION

1 Answer

1992 ford explorer missing with new coilpack ,wires ,and spark plugs . has new heads ,new gaskets, new injectors, new o rings


Did you gap the plugs to correct setting? You may want to check the fuel filter and maybe the pump-maybe low fuel pressure.

Mar 15, 2010 | 1990 Ford F250

1 Answer

Car sputters and no power, now it will not crank


Check the coil pack. they are common to fail and the engine will usually misfire for a while and then not start when it gets cold out. you can do a quick check by removing one plug wire at a time and having someone crank the engine. the spark should jump right down the tower the wire goes onto to the base of the coilpack. if this does not happen then you need to replace the coilpack first. take the 6 tork head screws out and remove the wiring under it that goes to the module. carefull not to mix up the wires under the coilpack or to the spark plugs. reinstall the coilpack and reinstall the plug wires and try to start the engine. i will look for a response incase you need more help. good luck.

Dec 31, 2009 | 1991 Buick Park Avenue

1 Answer

Won't start turns over getting fuel and fire


make sure you are getting spark through the sparkplug wires. a sparkplug tester is the easiest way, or take a wire off one of the plugs try starting it and have another person watch the wire to see if a spark is coming off the wire to the sparkplugNOTE set the wire close to the sparkplug but leave a small gap between plug and wire so you can see the sparks. if not getting spark check all fuses first, otherwise the coil could be bad. or it could have coilpacks and one could be badNOTE every coilpack has two studs for wire, sometimes only one side of coilpack works if so it is bad both sides haft to work.

Dec 17, 2009 | 1996 GMC Suburban

1 Answer

Change coil, sparkplugs, spark plug wires, icm and still no spark. take off spark plug wire put a good spark plug on it and ground it no spark with everything new.


Coil is bad
inspect for cracks
u could check for spark at the coil wire going into the distributer(center wire )

Sep 24, 2009 | 1992 Honda Accord

1 Answer

Why car will run then once shut off wont start again, at a later date it may start again and drive S IF NOTHIng is wrong. It will just spin a couple days later it may start again. checked gas-good also...


did u inspec condition of plug wires-they wear from heat etc-take that distributer cap off n I bet inside looks like dental decay--the ignition module is equal to the points and it fails-its under the cap n can be tested at a parts place

Sep 19, 2009 | 1992 Pontiac Grand Prix

2 Answers

Car has a skip and not firing properly on all cylinders


Before you go checking parts that aren't there, unplug each coilpack connector one at a time with the engine running. After unplugging a coilpack you should hear the idle drop. If you unplug a connector and there is no change in idle, that is your problem cylinder. You can then check to see if there is spark by removing the coilpack and touching it to a ground on the engine, you'll hear it click. If you have spark, check the spark plug, if the spark plug is good, it's most likely a bad fuel injector. You can verify a bad injector by doing a resistance test after removing the connector. Injector replacement is a nightmare on these cars, but it can be done without pulling the plenum if you're mechanically inclined. Visit www.zcar.com for more help.

Aug 20, 2009 | 1990 Nissan 300ZX

1 Answer

Replaced spark plug cables on 1997 chevy malibu and car will not start


Check firing order. the wires may be placed wrong, or your coilpack could be shot.

Feb 27, 2009 | 1992 Honda Accord

Not finding what you are looking for?
1992 Mitsubishi 3000GT Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

71288 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22059 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7009 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...