Question about 1987 Chrysler LeBaron

1 Answer

1987 LEBARON CONVERTIBLE WONT CLOSE ABOUT 3 OR 4 INCHES SHORT???? BACK WINDOWS OFF HOW DO I REPLACE THEM???

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,066 Answers

Tops shrink in cold weather.  You need to use a hair dryer to warm up the vinyl.

Posted on Mar 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I would like to see a how to video on the removal of the headliner on a 1987 Chrysler Lebaron


I've seen trim tools on Amazon. You never know what's available on You-tube for show and tell. Maybe check Instructables, a cool site.

Nov 24, 2013 | 1987 Chrysler LeBaron

1 Answer

1987 Chrysler lebaron won't start. I pulled the


Coupe, sedan, convertible, wagon, engine size? Also, do not use dielectric grease in computer connectors as this can cause a feedback issue transmitterd by the grease. Use white lithium only.

Aug 21, 2013 | Cars & Trucks

1 Answer

1993 Dodge shadow convertible, drivers side power window wont stay up, what does it take to fix it


YOU WILL NEED TO REPLACE THE WINDOW REGULATOR ASWEMBLY TO FIX THIS PROBLEM..

Aug 28, 2012 | 1987 Dodge Shadow

1 Answer

1995 chrsler lebaron rear passenger window


If you can get access to the motor try tapping on it while pushing the switch it will usually start working again temporarily, but as far as replacing the regulator assy. Trust me on this you're going to want to take it in and have it done, I've done a few at our shop andit is a huge pain in the rear...lots to re adjust once it's back together due to convertible..I personally hate doing them.. And I'm pretty sure you can only get the motor with the whole regulator assy..

Jun 10, 2012 | 1995 Chrysler LeBaron

2 Answers

Type of oil 1987 LeBaron


On 1987 Chrysler Lebaron 2.2L FI Turbo 4cyl...
Engine Oil Type/Weight/Capacity (use in temperatures ranging from 19 To 81 degrees)

Note :
Pennzoil Premium Motor Oil 5W-30
Castrol GTX High Mileage 5W-30

4.5 Quarts without Filter change.

Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day

Feb 14, 2012 | 1987 Chrysler LeBaron

1 Answer

1987 Chrysler LaBaron Convert. need to see fuse panel digram, can you help me?


you might find the fuse diagram on the inside of the fuse box cover .....cheers

Aug 12, 2010 | 1987 Chrysler LeBaron

1 Answer

92 lebaron convertable. When it rains, the top


If you out the top down, on the windshield side posts you will see a small drain tube on each side. When these cars age the sealant used around the drain tubes rends to get crushed and distorted and tends to cover these tubes not allowing the water to drain down the A posts. This causes the water to back up and run down the inside of the A post and under the dash and onto the floor. It's also possible that the window seals are in need of replacement or adjustment.

Jul 29, 2010 | 1992 Chrysler Lebaron

1 Answer

How to remove rear seat back 1987 mustang convertable?


Tools Required:
  • 3/8 inch Drive Ratchet
  • 3/8 inch Drive 3” Extension
  • 3/8 inch Drive 10mm Socket
  • 3/8 inch Drive 13mm Socket
  • T-50 Torx Bit
  • 1/4 inch Allen Wrench
  • 3/16 inch Allen Wrench
  • 1/2 inch Wrench
  • Drill Motor
  • 1/8 inch Drill Bit
  • 5/16 inch Drill Bit
  • 2 inch Hole Saw
  • Trim Tool (Fork Tool)
  • Electrical Tape
  • Center Punch
  • Hammer
------------------- Installation:

Remove Back Seat:
  1. Locate the retainers securing the seat bottom into the vehicle, approximately 10 inches from the end of the cushion, either side. Use your thumb to push in retainer release tab. Lift the seat up to remove.
  2. Remove the two 13mm screws securing the seat back, located on each lower corner. Lift seat upward to release seat back from brackets at the top. You can carefully prop the seat back under the retracted top , use caution if choosing this method not to damage or scratch the vinyl of the seat. You can remove the seat from the vehicle completely by disengaging the flanges securing the top of the rear seat to the fabric of the convertible top well .
  3. Remove Quarter Trim Panels:
    1. Grip the Quarter Trim Panel Cap at the shoulder strap opening and lift up to dislodge the retaining clips.
    2. The inside Quarter Trim Panels are two-piece panels. Remove the upper portion of the Quarter Trim Panel from the vehicle; it is not necessary to remove the lower portion. Pull the forward edge of the trim Panel over the pinch weld in the doorjamb.
    3. Use a Door Trim Tool (Fork Tool) to dislodge the pushpin retainer at the rear edge of the Trim Panel approximately 4” down from the top, pry Trim Panel toward the outside of car to release retainer.
    for more help click this link directly
    1. http://www.americanmuscle.com/05-07-lightbar-install.html ---------

Oct 05, 2009 | 1987 Ford Mustang

2 Answers

Back side windows will not work


could be a fuse or the motor for the window

Sep 10, 2009 | 1991 Chrysler LeBaron

1 Answer

1987 LeBaron won't start unless I pour gas into


Check you injector seals,you may be losing pressure in the fuel lines

Jul 16, 2009 | 1987 Chrysler LeBaron

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...