SOURCE: Fuse box cover missing on a 2003 kia rio.
ANY KIA DEALER WILL PRINT ONE OUT FOR YOU FREE. IF YOUR HAVE A FAX MACHINE YOU JUST SAVED YOURSELF A TRIP. CALL ANY KIA DEALER IN YOUR AREA AND ASK FOR PARTS DEPT. THEY WILL HELP YOU. GOOD LUCK.
SOURCE: where is the drain plug exactly on a 2003 kia rio?
For the 1.6l engines:
Looking at the engine from the front end (e.g. from the right fender), the drain plug is on the left below cylinder #1.
From beneath the car, looking towards the front of the vehicle, you'll find it on the right had end of the engine block, at the back (nearest the passenger compartment. (see image below)
You'll need a 17mm wrench or socket.
The Oil filter is above it and towards the center of the block.
SOURCE: how do i change the spark plugs on a 2003 kia rio
INSPECTION
1. Disconnect high-tension code from spark plug.
2. Remove the spark plug.
3. Connect the spark plug to a high tension code.
4. Hold the spark plug with insulated pliers 5~10mm from a ground.
5. Crank the engine and verify that there is a strong blue spark.
If there is no spark, inspect the following points.
Step Inspection Action
1 Check for good connection of ignition coil Yes Go to next stop.
No Repair or replace
2 Check if resistance of high-tension leads are OK Yes Go to next step.
No Replace
3 Check if the ignition coil is electrically charged
1) Ignition switch "ON"
2) Check if the engine coil (+) is electrically charged
Yes Go to next step
No Check the wire harness between ignition switch ignition coil and ECM
4 Check if resistance of ignition coil is OK
Resistance
Primary : 0.36~0.44Ω (at 68°F (20°C))
Secondary : 10.9~13.3kΩ (at 68°F (20°C)) Yes Go to next step
No Replace
5 Check if ECM is OK Yes
No Replace
REMOVAL
Do not attempt any maintenance on spark plug if engine is hot.
1. Disconnect negative battery terminal.
2. Carefully remove high-tension leads.
3. Use compressed air to blow any dirt or debris from around spark plug hole.
4. Check that spark plug fits squarely in spark plug socket and remove spark plug.
Raise a vehicle and install SST(OK552 131 001) in order to replace cylinder 2, 4, 6 spark plug.
INSTALLATION
1. Install spark plug into cylinder head.
Tightening torque : 18~22lb-ft (25~30N·m, 2.5~3.0kg-m)
2. Reconnect high-tension leads.
3. Reconnect negative battery cable.
SOURCE: knock sensor replacement
Turn ignition off. Disconnect knock sensor 3
-
pin harness connector. Locate knock sensor, on cyli
nder block.
On Optima 2.7L engine, sensors are located on both
sides of cylinder block. . Remove knock
sensor from cylinder block. To install, reverse rem
oval procedure.
SOURCE: 2003 kia rio I changed the fuel filter the car
had similar problem, 2003 rio 1.6l idle fine and die when trying to accelerate or lurch and die ran fine in reverse change timing belt,wires plugs, had codes for multi cyl misfire and low injector voltage, still same lurch and die. try wiggle test on sensor plugs and main engine harness between battery and engine . i did this and found car smoothed out,tried wiggle again and car died,took harness apart where i wiggled it and found broken wire to crank sensor.good now
489 views
Usually answered in minutes!
×