Abs light is on also Traction control light is on car runs find and brakes still work. Its a 1995 was told I need a module to fix problem. Ques. is how do I find this module does it have a certain name.

Sounds like a fault with the Antilock Braking System. The vibration in the pedal is the ABS working. With your foot on the brake pedal, it releases and re-applies the brakes to stop a skid from the wheels locking up. You need professional service for brakes.

Seems to be a known issue on all Cadillac and requires the ABS module to be replaced.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille

• Cached
• Similar

Cadillac DeVille ABS Light Due to ABS Control Module Failure. This is a verified problem based on 126 reports. Learn more about this problem, when it occurs ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville STS

• Cached
• Similar

Traction control and ABS lights stay on dash. This is due to ecbtm Module gone bad. replace Module and this should fix the problem. You can go by the VIN and ...

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > DeVille DTS

• Cached
• Similar

ABS Light Due to Control Module Failure on Cadillac DeVille DTS. The anti-lock ... ABS and Traction control light stays on. ... abs light to abs control stay on.

ABS Light Due to ABS Control Module Failure : Cadillac ...

repairpal.com > Problems > Cadillac > Seville SLS

• Cached
• Similar

ABS Light Due to Control Module Failure on Cadillac Seville SLS. The anti-lock brake ... SLS135,000Jumsee. Abs and traction lights stay on when started.

That means there is a problem with the ABS , has DTC'S - diagnostic trouble codes in the EBCM - electronic brake control module . You need to have diagnostics run on it !
Traction Control/ Stabilitrak Off: Refer to ABS Description and Operation in Antilock Brake Systems
This vehicle is equipped with the BOSCH 5.3 antilock braking system.
The vehicle is equipped with the following braking systems:
?€¢
Antilock Brake System (ABS)

?€¢
Dynamic Rear Proportioning (DRP)

?€¢
Traction Control System (ETS) (w/NW7)

?€¢
Traction Control System (TCS) (w/NW9)

?€¢
Vehicle stability enhancement system (VSES)

Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

try to clean abs sensor at each wheel

abs pump might be fryed

no it does not; this is a massive short in the electrical system and, requires the services of an auto electrician like myself.
take the car in to an ASE certified auto electrical shop and, stop spending money on temporary fixes
the technicians can read the schematics and, fix your car right

You must put oil in the engine

The traction control gets its information from the ABS system, so a faulty sensor reading will automatically shut down the traction control system.

It is common in this vehicle for the sensor to malfunction!

Brake system warning
Momentarily illuminates when the
ignition is turned to the START
position. Also illuminates if the
parking brake is engaged. If the
brake warning lamp does not
illuminate at these times, seek service immediately. Illumination after
releasing the parking brake indicates low brake fluid level and the brake
system should be inspected immediately.
Anti-lock brake system (ABS)
Momentarily illuminates when the
ignition is turned to the ON
position. If the light remains on,
continues to flash or fails to
illuminate, have the system serviced
immediately. With the ABS light on, the anti-lock brake system is
disabled and normal braking is still effective unless the brake warning
light also remains illuminated with the parking brake released.

Here is a link to your free owners manual with an explanation of all the lights and features of your car as well...

http://safemanuals.com/user-guide-instructions-owner-manual/LINCOLN/TOWN%20CAR%202000-_E

Click on the PDF user guide on the right side.

THE EBCM IS BAD this is the electronic control module that is on abs pump. you can replace seperate I think it is around 500 for part

the anti-lock brake system is part and parcel of the traction control system. the abs has a $750.00 valve located in the engine bay on the right side (as you face the car from the front) the driver's side just behind the headlight. i had a mechanic who took it upon himself to remove, dismantle and clean and reassemble the unit, all to no avail but also without expense. the cost of the part was prohibitive since Blue Book on this car is just about $700.00. it will run and brake just fine without the abs or the traction control system either.