Question about 2002 Honda CR-V

Open Question

I need location on 2002 crv pcv valve i was wondering if there is picture or video on how to find

Posted by on

5 Suggested Answers

baugh55grfmj
  • 225 Answers

SOURCE: pcv valve location

750cb0c.jpgIt should be on the rocker cover in plain sight

Posted on Dec 23, 2009

  • 18 Answers

SOURCE: location of pcv valve on chev 1500 pu

its either the left or right valve panel.

Posted on Sep 03, 2008

keemo68
  • 1263 Answers

SOURCE: nissan pickup 1994

the pcv valve is a one piece part(positive crankcase ventilation) its located on the valve covers and has a hose attached to it that goes to the air intake hose of the air breather. this is a simple installation. the pcv valve just slips into a grommet in the valve cover and can be pulled out and pushed back in with out any tools. please rate this... thanks

Posted on Sep 28, 2008

chrischronic
  • 235 Answers

SOURCE: 2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION

it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.

Posted on Feb 19, 2009

  • 449 Answers

SOURCE: location of Idle control valve on 04 CRV

It's not a easy job but I'm pretty sure you had one of those problems where the idle surges if this is the case take out the air intake tube that leads to the throttle body, get a can of carburetor fluid and spray around the throttle body. You will need someone to start the car and hold the gas peddle to 2500 rpm while you do this the car will shut of when you do this, restart the car and repeat the process until half of the can is used up. Now check your antifreeze level fill if needed and reset you check engine light. Now you can take the idle air back and get your money.

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of the pcv valve on 4.2 i6


These engines do not have PCV systems.

Feb 18, 2013 | 2002 Chevrolet TrailBlazer

3 Answers

How to change the PCV valve on a Avalon 2002? Where is it and do I have to remove anything first?....Thanks Novice


travisgunter_1.gif\
The valve just pulls right out of the hose that its in. No tools or removal of stuff necessary.

May 10, 2011 | 2002 Toyota Avalon

3 Answers

Replace the PCV valve on the '09 dodge grand caravan


Hello! Here is the location of PCV valve for 3.3L, 3.8L, and 2.4L....Guru....saailer



saailer_87.gif

Mar 08, 2011 | 2009 Dodge Grand Caravan

1 Answer

Hi I was wondering if you could tell me where I would find the pcv valve in my 2002 dodge dakota 8cyl 4.7L


Its located on the left side of the oil filler where you add oil. Slide out the breather hose and then twist and pull the valve out.

Jan 19, 2011 | 2002 Dodge Dakota Club Cab

3 Answers

PCV valve for 2004 Hona CRV


PCV Valve Operation: 0900823d80049deb.jpgA vacuum-controlled metering device that regulates the flow of crankcase fumes in the positive crankcase ventilation system by allowing more flow at high speed than at low speed, and acts as a system shutoff in case of engine backfire to prevent an explosion in the crankcase.
Depending on your engine size, the PCV is a different style and slightly different location.

Usually they are mounted in a hole on your valve cover.... connected by a vacuum tube.
Some are mounted with threads into the engine block (usually by the oil filter)

On the '04 Crv - it is nearly inaccessible behind the AC compressor and beneath what looks like an old vacuum advance. Most PCV valves today do not need to be replaced, unless there is actual valve failure, which I have not seen happen. I would not be concerned about replacing it.

Thanks for using FixYa - a FixYa rating is appreciated!!

Feb 21, 2009 | 2004 Honda CR-V

1 Answer

2002 LINCOLN LS V6 3.0 PCV VALVE LOCATION


it is down under the intake manifold. the intake manifold must be removed to get to it. this vehicle is known for developing a vacum leak in the elbow hose that connects to pcv valve, so ive done a few.

Jan 05, 2009 | 2002 Lincoln LS

1 Answer

Location of the PCV valave in the 2002 Honda CRV


pcv valve should be located on the valve cover..but some new vehicles don't have one it is built into the valve cover itself..

Dec 01, 2008 | 2002 Honda CR-V

2 Answers

PCV valve location


if i know what you are asking, look at where you put your oil in. on the valve cover to the top right should be a plug with a tubeing runs to your air clear tube where the air mass sensor and carb is located. i think that is what you are looking for.

Sep 05, 2008 | 2002 Ford Taurus

2 Answers

Pcv valve


this might help

http://www.autozone.com/N,315599/initialAction,repairGuide/shopping/repairGuide.htm?pageId=0900c15280075f05

Not the same year, but real close,

Also check maxima.org, or

http://www.courtesyparts.com/betasite/maxima-a33b-2000-2003/genuine-nissan-parts/-c-1956_1957.html


Jun 20, 2008 | 2002 Nissan Maxima

2 Answers

Pcv valve


The PCV valve is right smack dab in front of you when you're facing the oil filler cap of an 2002 MR2 Spyder. You need to take off the plastic facia (two nuts and two zip plugs) on the manifold and you'll see the PCV valve pointing out to the left on the left side of the valve cover.

May 15, 2008 | 2002 Toyota MR2 Spyder

Not finding what you are looking for?
2002 Honda CR-V Logo

Related Topics:

523 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6880 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...