Question about 1991 Ford F150

1 Answer

While driving just cut off and wont start. I replaced the icm and gave a full tune up.I have spark and fuel is getting to fuel rail what to do next? 1990 F-150

Posted by on

  • j_falbert May 11, 2010

    Try starting the truck with starting fluid. If it starts then you know all the spark/timing/ecm stuff is working correctly. If it starts then you need to see if you have the correct fuel pressure at the rail and check the injectors to see if they are getting power (you can use a noid light for that)



1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have you tried replacing the fuel filter maybe the fuel isn't being regulated probelly when driving

Posted on Mar 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My 1999 chevy express 1500 cargo van died while i was driving it.. won't start.. no spark. fuel pump is working..

any codes with problem ---if no codes check fuel pressure at rail/ spray into throttle body with ether/start fluid if start than fuel issue no start check egr valve for clog and or carbon problem also check fuses and relays

Jul 07, 2016 | Cars & Trucks

1 Answer

Surging and stalling

Get it check out call someone to do it for you

Jan 18, 2014 | 1999 Pontiac Grand Prix

1 Answer

1990 Deville, new fuel pump, new ICM, 40 psi on fuel rail, got spark, start the car and it runs fine for short time then dies. I have found out that something kills power to the injectors. Shut the hood,...

Replace the fuel Pump relay in the Power distribution box under the hood. Also, start checking the wiring harness back to the fuel pump for shorts. Most likely this is the relay cutting out every time it is pumped or jiggled but it is possible, however slight, that the problem is a short.

Feb 24, 2011 | 1990 Cadillac Deville

1 Answer

I have a Ford Bronco 1996. The night before, I started it, drove about 2 miles and parked it. Today, no start. It was cold at night here, around 30 degrees F. The next day, it was around 40 F. I tried to...

check fuel preasure i have seen fuel pumps go bad for no reason listen to the gas tank for the pump to come you should here it also i think some of them came with 2 fuel pumps 1 in the tank an 1 on the frame rail check it also if it has 2, also check fuel pump relay

Nov 28, 2010 | Ford Bronco Cars & Trucks

1 Answer

01 626 six started died started died has no spark now will not start had icm ck ok

Check your fuel rail pressure.With engine off,key on and cold wearing protective eyewear, remove cover cap relieve schader vavle, just like tire valve stem, on fuel rail with a eyeglass repair scewdriver($.99) at a drug store) the tecnnitions miracle pocket tool) by depressing the valve.No spurts.Fuel presure=low.Got gas? Check trottle position sensor with ohmeter 0 throttle 8-14volts at full open on the trottle lever(located @trottle body hub. Next step obd test by a pro.

Oct 31, 2009 | 1999 Mazda 626

2 Answers

Golf gti 2.0 8v keeps cutting out now it wont start

Just found your problem while looking for solutions to my own. My 2.0 8v 3door 97 golf gti can also cut out after driving for two or three minutes. Works fine one day then dies instantly 5 times the next...not a safe thing to happen pulling out of a junction!! Have researched problem and been told that it's probably fixable for £12-15. The "Hall Sender Relay" which is the fancy name for the ecu's power supply relay can go on the blink and cut power at any time causing instant shutdown...just like turning off the ignition key. Part number is 165906381 and available from a local vw dealer usually overnight. I'm fitting mine tomorrow 4/4/09...fingers crossed! Hope this helps others...worth a try for the cost involved.

Jul 14, 2009 | 1996 Volkswagen Jetta

1 Answer

96 Honda Civic died, then wont restart.

If you can hear the fuel pump cut in, try the mass air flow sensor. MAF.

Jun 23, 2009 | 1996 Honda Civic

Not finding what you are looking for?
1991 Ford F150 Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5648 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides