Question about 1999 Daewoo Lanos

Open Question

Where is the pcv valve in the 1999 daewoo lanos hatch located? can you please help?

Posted by on

5 Suggested Answers

MobyMech
  • 106 Answers

SOURCE: fuel pump on Daewoo Lanos 1.3

Hi

If my memory serves me right the Lanos has an immersed pump, and therefor you need to be looking either under the rear seats or in the luggage compartment for a round metal or plastic cover which when removed will uncover the top of the pump and fuel sender unit.

It is probably held in place by a large plastic or metal ring which either has to be unscrewed or just turned slightly to disengage the securing lugs.

PLEASE DISCONNECT THE BATTERY NEGATIVE TERMINAL BEFORE MESSING WITH THE PUMP OR YOU MAY HAVE AN EARLY FIREWORKS DISPLAY!!!

Just as a matter of interest, I assume when you say FLUIDS you actually mean FLOODS, in which case, the problem isn't the pump.

If the car doesn't start, or struggles to do so, and there is a smell of fuel or the plugs are getting wet, then the problem is more likely to be a lack of spark than anything else.

There are other scenarios, such as a faulty coolant sensor (cold engine), a faulty O2 sensor (hot engine), a faulty throttle position sensor (hot or cold engine), and a few others I could mention.

If you require any further help, just click ASK ME under my strange white round faced picture (which my MRS reckons looks just like me!!) and I shall be more than happy to assist you further.

Regards

Geordie

Posted on Jun 25, 2008

michigan man
  • 3533 Answers

SOURCE: pcv valve location

it is normally located on the valve cover itself look for the black tube going into the top of the valve cover gasket

Posted on Feb 04, 2009

  • 49 Answers

SOURCE: 2000 Daewoo Nubira PCV valve location.

Go to your local auto parts store and look for a chiltons or haynes repair manual for your make and model of car. 2000 daewoo nubria. They might already have one open and available for your reference, otherwise its probably $20.00 for one. Do a search online in a forum specifically for daewoos. there might be someone else that has this info available.

Posted on Feb 27, 2009

michigan man
  • 3533 Answers

SOURCE: cant find pcv valve

for the most part it is on the valve cover try this website to see if they have your car listed its www.autozone.com and another one to checkout is www.alldatadiy.com and ihope this help you out Michigan Man.

Posted on May 24, 2009

  • 6 Answers

SOURCE: Daewoo Lanos 1.4 1997 Idling really high - Idle Rev Valve?

hi there the problem describe is a common problem you need to take the car into your dawoo/chevrolet dealer as there was a reprogramme that need s to be downloaded to your ecu to fix the problem should only take about 30 mins so should not cost you to much i used to have around 10 to 15 a week to do

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Please show me a picture that shows the position of oxygen sensor on a daewoo lanos 1999 model 1.6 litre


Oxygen Sensor

1999 Daewoo Lanos 1.6L MFI DOHC 4cyl

The Oxygen Sensor is located: Under hood, driver side, lower engine area, above exhaust pipe flange, mounted in exhaust manifold,don't have a picture.Here's a link to what it look's like just remove the electrical connector,get a open end wrench and remove.. http://www.autozone.com/engine-management/oxygen-sensor/bosch-oxygen-sensor/daewoo/lanos/1999/4-cylinders-6-1-6l-mfi-dohc/4971_102074_1784_97999

May 25, 2015 | 1999 Daewoo Lanos

1 Answer

Why my daewoo lanos splashing oil on the breather pipe


it could be a blocked pcv valve on the tappit cover . that controls engine blow by , caused by engine wear. as the engine gets older the rings wear and combustion gasses escape past the compression rings and enter the sump , if there wasn't a pcv valve it would pressure the engine and blow all of the oil seals out, the pcv valve is there to control these gasses and return any excess to the inlet manifold . it is possible that this valve is faulty. it is also possible that you have over filled the engine oil and this may be causing a issue. or the worst case scenario is that the engine is worn and posibally needs new rings. depending on how many klms are on the odometer I would be looking at all options before going down that path, as it is a expensive operation . hope this is of some help to you

Dec 22, 2014 | 2000 Daewoo Lanos

1 Answer

Hi I have 1998 Daewoo Lanos Hatch back I am trying to located the spot where I can put a baby bolt in ? I cannot find it ! Thanks Tanya from Brisbane


In the 1999 Lanos Hatch, there is no bolt. There is a link where you can attach the standard clip. It's located in the rear centre of the luggage space. feed it over the back seat, in between the seat & the folding cover & clip in accordingly. You may need to buy an extension to reach it. Hoping this helps.

Mar 04, 2011 | 1999 Daewoo Lanos

1 Answer

Where is the heater control valve located in a daewoo lanos 1999


It is behind the dash, behind the climate control console, located on the heater core.

Download the service document below. The file is a compressed folder, unzip and open the HTML files containing disassembly procedure.

5T2_7A0.en.zip

May 24, 2010 | 1999 Daewoo Lanos

1 Answer

2000 Daewoo Lanos intermittently idles rough


check throttle body and pcv hoses and ports for blockage possible carbon build up and sticky iac valve

Jul 19, 2009 | 2000 Daewoo Lanos

1 Answer

1999 Daewoo Lanos SX is not idling properly even after I canges the MAP and the Throttle position sensors, what could be wrong?


go back to basics
do cylinder compression test, dry and wet
if compressions 25 psi lower than another one this can cause rough idle(valves leaking)
should be 150-180 psi any lower engine wear.
check pcv hose from rocker cover to throttle body especially port in throttle body for blockage.
are any codes being set?

Apr 16, 2009 | 1999 Daewoo Lanos

1 Answer

Where is the location of the possitive crankcase ventilator


Sir,
Just go through the Link. If you have not get ur answers, better to post a question on that site.


Thanks Good Luck
Appreciate to rate as "Fixya"

Mar 09, 2009 | 1999 Daewoo Lanos

1 Answer

Can i drive my lanos with suspect valve problem.


Are you sure your timing belt is on right? If you're out one tooth, it's gonna run like ****, and if it's not firing at all on one cyllinder, you're going to wash down the cyllinder walls (with gas while you're driving) and have engine failure. 400 K ? You might make it. Won't do your engine any good.

Feb 27, 2009 | 1999 Daewoo Lanos

1 Answer

Replaced timing belt not running right


The Lanos engine are an interference engine. If you have bent valves, remove a plug wire one at a time and see if there is no change in the idle. My guess, one of them isn't going to change anything. That would be the cylinder that has the bent valves in. I had a Lanos in my shop with a broken timing belt and the head had several bent valves. I wouldn't be surprised at all if you also have bent valves.

Jan 29, 2009 | 1999 Daewoo Lanos

Not finding what you are looking for?
1999 Daewoo Lanos Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70374 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...