Question about Hyundai Sonata

1 Answer

P0336 Code 99 Malibu, 3.1 engine. Engine light on. Code: P0336. When I erase the code the car runs without engine light on for one trip. When I stop and start again the engine light re-appears. The car seems to run ok although I believe it is using quite a bit of gas. Any ideas? Thanks Terry

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 56 Answers

The code P0336 is crank shaft sensor performance code.The sensor could be faulty and not picking up a good signal.The after erasing the code,the problem still exists ,so it is then a pending code and when you shut the car off and restart it the code reappears.Just another idea here ,if you have not had a tune-up recently(plugs,wires,airfilter,etc.)you could get unwanted codes and your engine will not perform as it should.This could cause poor gas mileage as well.John.

Posted on Mar 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Nissan d40 engine it is running in limp mode the di on-board check showed p0336 fault I replaced the crank angle sender cleaned all the wiring connectors and earth contacts but still the same


P0336 Crankshaft Position Sensor Range/Performance

www.obd-codes.com/p0336
Detailed information on troubleshooting and repairing a P0336 DTC code which has to do ... This diagnostic trouble code (DTC) is a generic powertrain code.

Oct 19, 2015 | Nissan Cars & Trucks

1 Answer

I cant get my check engine light to go off?


take vechicle by auto zone they will code scan it free see what causing check engine light turn on.if you replace sensor you need auto zone to erase code so check engine light stop turning on.

Apr 03, 2013 | 1998 Chevrolet Malibu

2 Answers

98 blazer 4.3 engine won't start code p0336, already replaced crank sensor


which crank sensor do you replaced ? the P0336 means P0336 Crankshaft Position Sensor A Circuit Range/Performance.

________________
autel maxidas 708

Feb 25, 2013 | 1998 Chevrolet Blazer

1 Answer

What sensor do i need to disable to set timing on 1998 nissan frointer


well lets start with warming up the engine. so run it for a while. stop the engine and unplug the throttle position sensor. restart the engine and rev it 2000-3000 rpms 2 or 3 minutes under no load (such as lights, blower motor, a/c and so on) and then run it at idle speed. check timing at idle using timing light and set it to 20+/-2 BTDC.after adjustment shut the truck off and replug the throtle position sensor back. this will however turn your "service engine soon" light on, because you have unpluged the sensor and ran the truck. you will need to erase the ecm memory/reset it/get code reader and erase code.
thats how you doit without nissan scanner aka CONSULT2.

Dec 26, 2011 | Nissan Cars & Trucks

1 Answer

Hi my gas cap serv light came on because my cap was broken i went and bought a new one and the serv messg is still on


You may have a leak in the EVP system, causing the light to stay on. It would help if you had erased the code with a code reader that allows you to erase codes in the PCM. Make sure the cap is tight and clicks at least 3 times, drive the vehicle a few miles. Stop the car, turn off the engine, then restart and drive. it may take a few "good" trips to be recognized by the engines computer borfore it turns off. If your comfortable with removing the NEGATVE SIDE battery cable for 30 seconds, then reconnecting it and make sure it is clean and tight, you can try it to see if this helps turn off the light faster. If not, you may have another issue regarding the EVAP system.

Sep 20, 2011 | 2005 Chevrolet Malibu Maxx

1 Answer

My truck has had the check engine light on for awhile but was running ok. All of a sudden it started running like ****.


Its a tough one without knowing what the Check engine code is.. A trip by your local Autozone, Advance or nearby parts store should be able to get this info for you. These stores will retrieve the code for you... but they usually will not erase it.. hope this helps..

Aug 18, 2011 | 2004 Ford Ranger

1 Answer

Code p0336 starts hard tach wont work obd11 07 cobalt


P0336 means Crankshaft Position Sensor A Circuit Range/Performance. Try replacing the crank sensor next.

http://www.check-engine-light.com

Sep 05, 2009 | Chevrolet Cobalt Cars & Trucks

1 Answer

Chevy malibu check engine light on code P1665 what


P1665 Evap vent solenoid control circuit

Aug 30, 2009 | 1999 Chevrolet Malibu

1 Answer

2000 sunfire has p0336, p0340, p0130, where to


p0130 is an oxygen sensor code.
p0340 is your camshaft position sensor code
p0336 is your crankshaft position sensor code

as far as the p0130 code those usually are what i call neglected sensors that do not get replaced when they should be. this sensor is expensive but worth the money as it will help on fuel mileage.

on to the camshaft position sensor, i would start here with this. replace that sensor and when you are replacing it, inspect the sensor and make sure the electrical wires going into it are in good shape. after replacing those 2 sensors, go to a parts store who can erase your codes to turn the light off and then let us know if it comes back on and then we will go from there on the repair.

Aug 05, 2009 | 2000 Pontiac Sunfire

1 Answer

I do not have any fire from the coil and engine code P0336 shows.


Did you put in a used engine, do you have the crank sensor off the other engine? If not, without looking at it I would suggest replacing the Crank Sensor.

Mar 12, 2009 | 1998 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

1,479 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...