Re: replace sunroof glass instructions for 1994 Acura...
No you should not have to take the head liner out.. when the sunroof is open you should see 3 or 4 screws one both sides.. all you have to do is remove the screws but its better to have a second person so they can hold the glass while your removing the screws so you don't drop the glass..then just put on some cloth gloves(prefered) to hold up and install the new glass. do removal in reverse to install.
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
you should have a round handle (looks like a big flat pancake, but with teeth on it to grip it). It fits into a slot located in the headliner directly behind the sunroof, rear of the interior light. Use that to close the sunroof.
you need to replace glass or is it leaking if leaking then you have to remove upper seat belt covers pop off remove bolt 14mm and the trims on upper pillars pry off carefully held in by clips remove covers on interior light at front where sunroof switches are there are screws by bulbs disconnect connector remove center light cover and screws disconnect connector with clean hands remove rbber trim around sunroof opening and plastic cover on each side of sunroof glass held on with plastic screw clips then remove four 10mm nuts lift sunroof glass out of car remove cover and screws from rearview mirror all plastic trims around headliner move pass seat forward most and flip back rest all way down roll pass window fully down then slide headliner out of car now you can remove electrical connectors and remove water flow hoses from sunroof unit remove 8 12mm nuts holding frame to roof remove through door you will see the track sunroof slides on remove nuts along problem is silicone between track and frame is deteriorated lift track clean replace silicone reattach frame to roof dont put trims or liner in till test connect switches and glass to frame make sure sunroof works and closes fully then go through car wash to see if leak is fixed
THE ELECTRIC DRIVE SYSTEM FOR POWER SUNROOF IS NOT ADJUSTABLE.DONT REMOVE THE SUNROOF MOTOR UNLESS THE SUNROOF IS COMPLETELY CLOSED.OTHERWISE A NEW MOTOR WILL HAVE TO BE INSTALLED AND TIMED WITH A TOOL THAT COMES WITH THE NEW MOTOR.THE GLASS PANEL CAN BE ADJUSTED.OPEN THE INTERIOR SUNSHADE ALL THE WAY BACK AND OPERATE THE SUNROOF UNTIL FULLY CLOSED.THERE ARE THREE GLASS MOUNTING SCREWS ON EACH SIDE OF THE SUNROOF OPENING.INSIDE THE VECHICLE LOOSEN THE SCREWS SET THE FRONT EDGE OF THE GLASS TO BE JUST 1MM BELOW THE SURFACE OF THE ROOF.ADJUST THE GLASS AT THE REAR EDGE TO BE JUST ABOVE 1MM THE ROOF AT THE REAR TIGHTEN THE SCREWS.
The Belt Diagram should be on the underside of your hood, however they have a way of disappearing.
If it is not there: Click on the following free direct Link. It has the correct Serpentine and Drive Belt Diagrams for your 1994 Acura Integra 1.8L 4-Cylinder Engine. Included are Instructional and Directional Diagrams for your use.
Let me know if this helped, or if you have additional information questions. Feel Free to contact me at FixYa.com!
You need to be in the medium or higher range of skill to do this. I am recamending you get a set of directions and go over it very carefully. Retracking a window can be painfull for some one who has done it before. If you don't have or cant get a set of directions then you really need to think about having it done. I would recamend having one with no motor put in.. Nothing to break on it. The tracks and clips are really tough.