Question about 1993 Toyota Camry V6

1 Answer

1993 Toyota Camry AM2 Fuse keeps on blowing

I need some advice to see how i can solve this problem. also which area should i look for the short circut.

Posted by on

  • Anonymous Mar 21, 2009

    RADIO!! Problably not. AM-2 is a 30Amp fuse, if the fuse blows when the key is turned to the first or IGN position then it may be: the (N 2 Noise Filter), Ignition Coil, I 2 Igniter, an Injector or a stray ground. Have you determined when it blows. This is assuming you have a 4 Cyl & Automatic Transmission.



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.


    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 104 Answers

If this is a stock radio the fault is going to be in the wiring between the fuse and your radio look for damaged wires that can short to ground. You should also make sure nothing is tapped into that circuit (more common in aftermarket radios)

Posted on Mar 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My Camry keep blowing am2 fuse

Dear sir

I think there is some short circuit between two contact/terminal.

Hope answer the question

Jul 19, 2016 | Cars & Trucks

1 Answer

My 2000 Toyota Camry has coil packs and still keeps blowing am2 fuse

More than Likely, you have a Short on that System and it is causing the 2Amp Fuse to blow. 2 Amp's is not very much, there is getting more than 2 Amps and the most likely cause is a Chaffed Wire that is feeding back into the system...

Mar 25, 2015 | 2000 Toyota Camry

1 Answer

My 2000 Toyota Camry am2 fuse blows when I turn ignition on

If the IGN fuse is not also burned, likely there is a shorted ignition coil or grounded ignition coil power wire. If the IGN fuse is burned then look for a possible shorted light bulb

Mar 25, 2015 | 2000 Toyota Camry

1 Answer

My 2000 camry am2 fuse keeps blowing

find short in cables u do have a short

Mar 25, 2015 | 2000 Toyota Camry

2 Answers

The AM2 fuse under hood keep blowing out every time i turn the ignition key switch to on position

I would disconnect the noise filter located by the ignition coil/ignitor, have seen them short out and cause the AM2 fuse to blow. Also Disconnect coil, dist and see if short goes away

Dec 07, 2011 | 1994 Toyota Camry

3 Answers

Why does me AM2 fuse blow on my 96 camry le 2.2

There is a capacitor/condenser that is used for noise suppression/static. It is attached to the post of the coil. They melt and short out blowing the AM2 fuse. You can clip the wire for now and it will run fine. The condenser can be purchased at the dealer for about $8 but the distributer has to come out to change it.
...stolen from another webby

Nov 24, 2011 | Toyota Camry Cars & Trucks

1 Answer

1993 pasco blowing am2 fuse

a wire is shorting to earth so blowing fuse or what ever is on the fuse blowing circuit is drawing excessive current

Jul 05, 2010 | 1993 Toyota Paseo

2 Answers

No spark/no fuel.1995 toy. camry 2.2 5S=FE

The BONNET is the hood, You must have talked to someone from ENGLAND. The fuse may blow if the coil or the igniter is shorted. Turn the key on and disconnect the igniter and coil, then hook up each one and see when the fuse blows.

Nov 23, 2009 | Toyota Camry Cars & Trucks

1 Answer

AM2 fuse keeps blowing, what do I do

if your am2 fuse keeps blowing your have a short in your ingitor wire that comes out of the distribitor the plug with two wires that runs to the firer wall!

Oct 30, 2009 | 1993 Toyota Camry V6

1 Answer

Car wont start

Fuses AM1 and AM2 power the ignition switch.

If you have any other questions, please feel free to respond.

Thanks for choosing FixYa for assistance.

Jan 19, 2009 | 1993 Toyota Camry V6

Not finding what you are looking for?
1993 Toyota Camry V6 Logo

Related Topics:

892 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8729 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides