Question about Ford E-250

1 Answer

No power to van after front end collionand air bags deployed is there a reset or somethinf you have to do?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 76 Answers

Most fords have an inertia switch under the passenger side dash on the firewall. it usually cuts off power to the fuel pump but it may be something to try on the e-250 they may have change to cutting off the power completely.

Posted on Mar 07, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to replace or reset airbags for 2004 cavalier


when a deployment occur . You need to change both air bag module, change SDM (supplemental deployment module)
need to change the SIR coil Inside column steering and the front discriminating sensor.
Befor installing you need to remove the SIR fuse or disconnect battery
no reset needed

hope it help

Oct 15, 2014 | 2004 Chevrolet Cavalier

1 Answer

Repair deployed airbags on chevy malibu 2005


You will not be able to perform this repair without a scan-tool that can communicate with the Air-Bag system. This tool allows the mechanic to look and test affected components. It also allows the system to be reset, after the necessary repairs are completed. The Air-Bag deployed because the Air-Bag Control Module detected an impact. If you replace the air-bag before any necessary repairs are completed and before the system is reset, the new air-bag will deploy as soon as it receives power.

Mar 07, 2014 | Cars & Trucks

1 Answer

I own a 2001 ford focus what components need replacing after air bag deployment eg. driver and passenger side


new air bags steering wheel etc and a new srs moduel then it needs reseting buy some one with a reset tool

Sep 26, 2012 | 2001 Ford Focus

2 Answers

My wife got stuck in a small snow bank & the


after a car has its air bags go off or even oddly think that they have been deployed then the car wont let it start for saftey reasons untill the system has been replaced.

Dec 28, 2009 | 2000 Honda Odyssey

1 Answer

I own a 2002 Ford Explorer. My air bag light


sometimes you can disconect battery for a few min. and computer will reset

Dec 03, 2009 | 2002 Ford Explorer

2 Answers

Hit a deer and airbags deployed; some front end damage to vehicle; what do I need to do to replace airbags and get them functioning again? (especially with regards to airbag sensor)


the air bags are very costlly, like around 2,000-4,000 eachwith out labor. the sensors are a few hundred also. when you replace the air bags you should replace all of the sensors. very expensive. for that kind of money you could almost get a new van. using junk yard air bags i don't suggest. to risky.

Nov 10, 2009 | 1998 Ford Windstar

1 Answer

Airbag light flashes four or five time then pauses and repeats.


The automatic air bag sensor is tested EVERYTIME to start the car/van. Your system has detected a failure in the Air Bag deployment sensor. It is not dangerous... but the air bag with the faulty sensor will not deploy in an accident.

Oct 11, 2009 | 1998 Ford Aerostar

3 Answers

Air bag


the threshhold on most cars is 15 MPH!!!

Jun 26, 2009 | 2006 Ford Taurus

1 Answer

How do you reset an air bag light in a 1996 Pontiac Grand Am SE?


The airbag light staying on could be an indication that the abs computer ( located under passenger front seat ). may have gotten wet. These cars usually let water in from the front strut towers. The light staying on indicates a problem with the computer, possible things that could happed:
a: air bag DOES not deploy in an accident.
b: air bag does deploy for no reason whatsoever.

either of those could be bad.

best to have it inspected by a certified abs tech or the dealer

Jan 04, 2009 | 1996 Pontiac Grand Am

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

64052 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...