Question about 1994 Buick Park Avenue

2 Answers

Noisy when I turn the wheels. 1994 Buick Park Avenue

It doesn't squeal like a belt but it does make a noise when I turn the wheels, especially if it is a sharper turn. Any suggestions what could be the problem?

Posted by on


2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Buick Master
  • 6,674 Answers

May be wear tabson front pads, warning you that brakes are getting low. Possible build up of rust on outer edge of rotors, is a pretty common cause, then rubs slightly on spindle during turns, from deflection. If it's a squeek, more than squeel. Remove wheels, tap edges(corners) , front & rear on outer edge, of rotor to remove & it usually goes away.Have a look at brake pad wear while your there. Use eye protection!

Posted on Mar 06, 2009

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Well make your power steering pump is fucked by the sounds of it.

Posted on Mar 06, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1994 buick park ave.

I doubt it has anything to do with the transmission.
When the brake pads wear most have a wear sensor that drags along the rotor.
Have you pulled the wheels and checked the brake pads ?

Jul 03, 2012 | 1994 Buick Park Avenue

1 Answer

Where is vehicle speed sonsor in a 1994 Buick Park Avenue?

The actual speed sensors are in the wheel hubs their are four sensors one at each wheel

Aug 23, 2010 | 1994 Buick Park Avenue

2 Answers

Crank shaft pully makeing a lot of noise

needs to be replaced, rubber bushings are possibly worn causing these noises. This could eventually allow the outter and inner parts of the pulley to separate.

May 22, 2010 | 1993 Buick Park Avenue

1 Answer

97 buick park avenue 3800 motor making a noise in the top end but sounds like a knock but hasnt effected the performance of the car just noisy

It is probably a noisy wrist pin on one cylinder,
also known as "a death rattle"
GM had this in their 2.2 engines,

Dec 16, 2009 | 1997 Buick Park Avenue

1 Answer

Super charger noisy

If the s/c is making a knocking noise that goes away when the throttle is pushed, you could have a coupling problem. Remove the s/c belt, grab the pulley and quickly twist the pulley back and forth from the 10 to 2 positions. There should not be a clunking noise and slowly moving the pulley you should feel a drag while the rotors move, no drag immediately means the coupling is bad.

Nov 03, 2009 | 1998 Buick Park Avenue

1 Answer

I have a 2000 Buick Park Avenue. Sqeal coming from belt area

yes the tension needs to be adjusted or they sell belt dressing to spray on at the auto parts store

Jul 31, 2009 | 2000 Buick Park Avenue

1 Answer

How do I access and remove the ignition switch from a 1994 Buick Park Avenue

if im not mistakin u have to take off the steering wheel, lock plate, then the turn signal cam and there is a torx screw under all that holding it in

Jul 08, 2009 | 1994 Buick Park Avenue

2 Answers

I have a '97 Buick Park Avenue Ultra front left growling noise

sounds like a wheel bearing if you don`t hear a clicking it is a bearing

Feb 23, 2009 | 1999 Buick Park Avenue

1 Answer

97 Buick Park Avenue.

it means that your brushes inside the blower are bad and the bearinginside is worn as well replace the blower motor the problem will be solved...please rate...thanks

Sep 25, 2008 | 1997 Buick Park Avenue

Not finding what you are looking for?
1994 Buick Park Avenue Logo

145 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts


Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides