Question about 1992 Ford Taurus

1 Answer

1997 villager quits after riaching runing temp

The van runs very good til raeche runing temp.them it quit when it cool off it will start again [when it quit it loses the signal to fuel injector]

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 4,369 Answers

You have a failing distributor. Buy one on Ebay.
Also, go to this site for files & help on Villagers

http://autos.groups.yahoo.com/group/villagerquest/

please rate a sfixya if this resolves your issue. Good luck

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 plymouth grand voyager runs normally but shuts off when it reaches operating temperature, won't start until it cools down. There is a smell of burned rubber, but can't find anything hot or that can...


First thing i would try is to carry a can of WD-40 or quick start with me and when it quits and won't start, remove air intake hose at throttle body opening, open throttle enough to give a good spray inside throttle body, release throttle, then try to start it . If it starts and runs momentarily, you have a fuel delivery problem. If not you have an ignition problem. Then you can start troubleshooting from there.
Or you can carry something to test for spark. I just find this way easier. Don't know when/if fuel pump has ever been replaced, but not uncommon for them to work when cool and quit pumping when they get warmed up, even though they sound like they are still working. That's where a fuel pressure test would also confirm, keeping in mind pressure may read good when first started but will drop later when warmed up and engine quits.

Apr 09, 2011 | 1997 Plymouth Grand Voyager

1 Answer

Runs fine til the temp out gets hot enough then dies. Wait ten mins and it will start again and run for a few mins then dies again


you didn't say if it was hot on the temp gauge? no matter, it sounds like you have a stuck t-stat. when the engine is cold, a mechanical valve keeps the water from coming out of the engine block until warmed up, then opens and lts the cooler water in. this cools down the engine and the colder temp of the water shuts the valve again. this happens constantly while the engine runs, and if your t-stat is stuck, the engine heats up the water in the block, but with nowhere to go, simply overheats the motor. a good repair book will locate the thermostat housing for you and should you the repair procedure. (i assume you have checked the water in the rad. low water will give you same symptoms). good luck.

Jun 10, 2010 | 1998 Chevrolet Express

1 Answer

1999 Buick Lesabre quits running


Clean battery cables and replace bolts/

Jul 06, 2009 | 1999 Buick LeSabre

2 Answers

No spark after warming


it could be your coil. if it is shorting out internally

May 08, 2009 | 1989 Mazda B-Series

3 Answers

No heat in my villager


you have air trapped in the engine. very common. park van uphill, fill radiator & reservoir, turn on heater, leave cap loose. wait for engine to warm up to burp air.
also see

http://autos.groups.yahoo.com/group/villagerquest/

Dec 05, 2008 | 1997 Mercury Villager

1 Answer

1996 mercury villager quits running


It may be the camshaft sensor in the distributor. Sometimes the optical sesor can be cleaned. Most times, need new distributor or reman from ebay.
do not replace the knock sensor, it is never bad. ANd, it is in the middle of the engine. $1000 repair for nothing.

See this ste too.

http://autos.groups.yahoo.com/group/villagerquest/

Nov 15, 2008 | 1996 Mercury Villager

1 Answer

Chrysler 3.3 vin r v6 mini van, starts then dies


Charlie. You have replaced the ECM on your van?.
Kedwin,, Your problem is, the computer on that 3.3 L.
Need to be programed with the VIN nember of your car.
The Antitheft System will disable the injectors due a incorrect VIN, Bucause the body computer is not recieve the correct pasword between 5 seconds after start up.
YOU have 2 options. 1 get a ALOHA Smith. some of they have the computer required to program ECMs.

The other option is: Get a new ECM from the dealer, They will program if ask for that.

NOTE:::::: Other way is . Put the body control module with the computer from the same car.

OK... I hope this work for yours.
If NOT letme know I can look for more information.
Thank you.

Jul 02, 2008 | 1997 Dodge Caravan

Not finding what you are looking for?
1992 Ford Taurus Logo

Related Topics:

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...