Question about 1999 Toyota Camry

1 Answer

How do I remove the efi relay/fuse on my 2001 camr. Pulling it straight out doesn't work.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

You have to slide the small bit of plastic that holds the fuse in the fuse box out of the fuse box and losen the screws that hold the fuse in place.

Posted on Apr 18, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

15amp efi fuse blows

It is not related to car being cool down , I think you are having ignition switch on . The EFI fuse goes directly to the contact switchin the EFI relay. Maybe try removing the EFI relay, turn the ignition to ON, and see if the fuse blows.
Doing this, the car won't start, but it might give you a clue as to where the short circuit is located. ... Check the fuse/relay box next to the driver side fender in the engine compartment.

Apr 03, 2015 | 2003 Pontiac Vibe

3 Answers

Have a 2001 Ford Sport with 93000 miles...have recently encountered a starting problem, starts and runs find and out to the blue it will crank but won't start, let it set for a few minutes and

Electrical devices with coils can develop hair line cracks in the windings which can expand and contract with temperature changes, causing intermittent problems. Most likely in you case are crank or cam location sensors or coil/ignition modules. Have you checked for spark at plugs when failing? Also relays can act this way. Check ignition relay and EFI relay.

Dec 28, 2014 | 2001 Ford Explorer Sport

1 Answer

Stalls when driving

I am having the same issue with my sister 2001 corolla. I pinpoint it down to the EFI and/or Engine Main relay. After you drive it for 30 minutes it just shuts off. Try disconnecting the EFI fuse (15 A) for 30 seconds. This will reset the ECU which is going into Limp mode due to relay malfunction. Let me know if it works, i am going to change the relays on my sister's car tomorrow and recheck.

Mar 18, 2014 | 2001 Toyota Corolla

1 Answer

Can not get horn to blow on a 2001 malibu

2001 malibu horn fuse and relay are located in the under the hood fuse box.
location 21 should be the relay
location 43 should be the fuse.
if the relay is put in wrong the horn will not work. if you replaced the relay and the horn stopped working try pulling the relay out and turning it around. and try the horn again.

Feb 07, 2014 | 2001 Chevrolet Malibu

2 Answers

Where is fuse for fuel pump 1993 camry

There is not a special one, it is supplied through the 30A AM2 fuse and the EFI main relay. Sometimes this relay sticks. Try pulling it out and tapping it gently, then replacing it. See here, p279

Mar 06, 2013 | 1993 Toyota Camry V6

1 Answer

Why does my efi fuse keeps popping 1999 chevy prizm

Pull the EFI relay, replace the fuse, and see if it blows when you turn the key on. If it does not turn the key off, reinstall the EFI relay and remove the circuit opening relay/fuel pump relay. Turn the key on. If the fuse blows than we know the problem is One of the O2 sensors, the IAC, the purge solenoid, or the ECM You can unplug the O2 sensors, iac, and purge solenoid. Replace the fuse, turn the key on, and plug them in one at a time until the fuse blows. Replace that component. If the fuse blows with those unplugged than its probaly the wiring and possibly the ECM. let me know what you find and I'll help you more if needed.

Aug 05, 2012 | 1999 Chevrolet Prizm

1 Answer

The fuel pump relay is the EFI relay in trhe fuse box under the hood right fender. I replaced it and the pump is working I can smell the gas. The truck still will not start. any sugestions?

Have you checked to see if it has spark at the spark plugs, let me know. Actually there are two relays for the fuel pump, the EFI relay and the circuit opening relay, the circuit opening relay gets voltage from the EFI relay. If the computer doesn't get a spark confirmation signal while cranking then the injectors are shut off.

Oct 22, 2011 | 1990 Toyota Pickup

1 Answer

Engine turns but car wont start...fuel pump working fuses ok fuel pump relay ok battery fine...sounds like car has no fuel but has half a tank

check to see if your efi fuses are okay maybe your injectors are not working. if this happens there will be no fuel entering the cylinders

Jan 04, 2011 | 2001 Saab 9-3

2 Answers

Where is the turn signal flasher relay located on a 2001 f150

2001 Ford Truck F250 Super Duty P/U 4WD 5.4L EFI 8cyl the Flasher is located front seating area, driver side, behind left hand side of instrument panel, on fuse panel. Check the FUSE PANEL...


Also can check this and other details in your 2001 Ford F-250 - Owners Manual. (page 172 and next).

Good luck (remember rated this help).

May 13, 2010 | 2001 Ford F250 Super Duty Super Cab

Not finding what you are looking for?
1999 Toyota Camry Logo

Related Topics:

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

77186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8737 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides