Question about 1992 Dodge Stealth

1 Answer

1991 dodge stealth with auto trans will not go into overdrive light on the dash cluster is working

Posted by on

  • Anonymous Apr 01, 2014

    raining out

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I knew my 95 stealth overdrive was going bad i was driving in overdrive and the engine would rev up for a second hardly noticeable surging and it just stoped pulling i turned the button off and it will do fine in drive bottom line the piston seal in overdrive drum is bad rebuild it

Posted on May 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No overdrive?


The overdrive works in serial with the indicator light on the instrument cluster,( OD) light, from here there a positive that feed one section on the control. Fix the short on the dash cluster then your overdrive become to work properly

Feb 09, 2015 | 2002 Hyundai Accent

1 Answer

I replaced the trans in my 1991 ddge stealth es and trans fluid came out where do i putit back in at?


You add trans fluid through the trans dipstick tube (NOT the engine oil dipstick). Check your owners manual for the proper method to test the level, most cars lately you check the level with the trans fully warm, in Park, engine running, parked on a level surface. (Set the parking brake, block the wheels.) You will need a long funnel, available at any auto parts store. Do NOT overfill the transmission, as this will cause damage to it.
Use the correct type of trans fluid, check your owners manual.

Aug 24, 2010 | 1991 Dodge Stealth

1 Answer

On 1991 dodge stealth on the dash lights I have


yeah its probably a bad sensor in the coolant overflow jug. it thinks you're out of coolant when it goes bad. some cars you can just buy the sensor but most are made into the jug and you have to buy the whole resevoir.

Apr 21, 2010 | 1991 Dodge Stealth

1 Answer

How much trans fluid capacity in the manual 5 speed dodge stealth


never change filter as i dont think it exsists. The fill should be located on the transmission up from the drain. You fill untill fluid pours out and stops then replace plug. Car must be level.

Apr 19, 2010 | Dodge Stealth Cars & Trucks

1 Answer

I am trying to find which fuse belongs to the turn signals because they are not marked and I do not have a manuel


1991 Dodge Stealth 3.0L MFI DOHC 6cyl
The turn signal and hazard
signals worked with "flashers". The Flasher is located: Front seating area, driver side, under dash, mounted on kick panel.

Good luck (remember rated this help).

Jan 31, 2010 | 1991 Dodge Stealth

1 Answer

1991 toyota p/u auto trans wont shift to overdrive


The trans in your truck had some problems in that era with overdrive. You will need ot check a few things to be sure it is not internal. The overdrive would often fail in those units due to the o rings used instead of lip seals.

Check the temp sensor. If it is bad the trans will not go into od. A defective solenoid in the trans for overdrive could cause it not to go in.

Check the fluid, if it is black, you may have burnt the clutches. I have know people who have driven the toyo's for years with no od. It is the same as the old three speed auto.

Hope this helps

Nov 19, 2009 | 1991 Toyota Pickup

1 Answer

Overdrive stopped working 97 dakota 318 auto


has the vehicle speed sensor been replaced? that is what controls when the trans shifts into od

Sep 14, 2009 | 2001 Dodge Dakota

1 Answer

Tranny wont shift from third gear.


You have a solenoid bad in the trans. Will need to drop the pan to replace part. Most likely a code is stored in the computer to help direct the technician.

Jul 14, 2009 | 1991 Dodge Stealth

1 Answer

1992 Dodge Stealth Auto Trans. Won't go into overdrive?


I had the same problem. The seal in the tranny that applies pressure to the overdrive clutches had blown out because the clutches had too much wear and the piston with the seal on it was coming out of it's bore causing the seal to rupture. Sounds complicated but there's a somewhat easy fix. The assembly on the passengers side of the tranny (jack up the car and remove the wheel) with about five bolts holding it on, is the complete OD clutch and piston assy. You can remove the bolts and remove the assembly, then inspect the clutches and the piston seal without removing the tranny. I pulled the parts from another tranny I had, but any transmission shop should be able to get them for you. Good luck.

Dec 31, 2008 | 1992 Dodge Stealth

Not finding what you are looking for?
1992 Dodge Stealth Logo

Related Topics:

329 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...