Question about 2002 Mazda 626

1 Answer

2002 Madza 626 4cyl car will not start. Has spark

2002 Madza 626 4cyl car will not start. Has spark to plugs no gas is going to the fuel rail, car was empty of gas there is no fuel reset on this model. Could it be a rely switch and if so which one is it.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 96 Answers

It could be: clogged fuel filter, bad fuel pump, or the cutoff switch. Could be fuel pump relay. It's in the engine compartment fues block, and labeled "Fuel Pump"

If it's either the filter or the pump, replace both at the same time, it's cheaper.

The fuel cutoff in located in the trunk, along the driver side rear fender, you have to pull all the carpeting and such out on that side to get to it. It's marked "Fuel cutoff" Not sure on the 626, you might just have to push the reset button on the module.

However I doubt this is your problem I would think it's either the relay, the filter or pump.

Posted on Mar 06, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 2002 chevrolet silverado cranks but wont start


use some starting fluid, spray a little bit in the carburetor then try to start it, it should start,if not check for spark at the spark plug and there is a little valve on the fuel rail it has a black cap on it looks just like a cap on the tires take the cap off and push the pin in and see if gas comes out if you have spark and gas it should start

Dec 12, 2016 | Chevrolet Cars & Trucks

1 Answer

2002 Galant Mitsubishi what should I look for a while wont start cranks over but it won't start


fuel pump to fuel rail
and spark to the spark plugs

2002 getting on
could be a sensor failure

26371265-3xkaasytmjosvrcn3xywmfwn-3-0.jpg

Nov 25, 2016 | Mitsubishi Cars & Trucks

1 Answer

Cranking but not starting until second try.gas smell.Gas line replaced.Had spark plugs, fuel filter changed.Still having starting issues and today noticed leakage near gas tank.


Gas line was only repaired, not replaced. I don't repair gas lines because of this problem. The entire line is replaced, both of them, supply and return. From the tank to the injector rail. This is the reason for the long start. Loose of fuel pressure.

Aug 07, 2016 | 2002 Subaru Outback

1 Answer

Is there a reset for the computer other than unhooking the battery or a reset for the fuel pump?


Could be the pump. Do you have the pressure at the fuel rail? If you have pressure and spark, then the noise you heard was probably lifter tap. No oil or over heated.

Jul 30, 2015 | 1999 Dodge Durango

1 Answer

My van will barely start only if I push the gas pedal to the floor. And still then will die almost right away. I can smell tons of gas, Plugs are wet with gas too. I did change the o2s and have the same...


I don't think it is your O2 sensor especially from the catylatic, because you mention smelling like gas and presence of gasoline. "Plugs" hopefully referal to the spark plugs, try to trace where you see gasoline and where it is coming strongest from. This is a case of leaked fuel line, fuel rails, fuel injectors.
1) Trace the source of where it is wet, there maybe a leak somewhere and you car is not getting the amount of fuel pressure to combust and thus make the engine dies. 2) Check your fuel injectors, fuel line rail, could be leaking or become loosen and is spraying gas when the fuel line is pressured into the spark plug socket. 3) You may have a dead spark plug one or more, and isn't combusting the gasoline, thus creating no compression leading to engine dying. 4) Leaking head gasket. Best is tracing where the gas is spewing from. That should help.

Jan 29, 2011 | 2002 Dodge Caravan

2 Answers

My 2002 hyundai accent will not start it is cranking but will not start i replaced the ignition coil and spark plugs and the 30a ignition fuse i did this on several different days after each one it started...


Hi, can you do a little troubleshooting for us to help diagnose? Need to know if you are getting sparks and fuel to the fuel rail. Methods are provided in the following post: http://www.fixya.com/cars/r5821173-doesnt_car_start_gasoline_engines
If you can run some of these checks and get back to us with results, we can better help you to get your car started. OK?

Jan 11, 2011 | 2002 Hyundai Accent

3 Answers

2002 ford ranger will not start. I know voltage is at the spark plug and I can hear the fuel pump prime when the ignition is turned.


First is voltage at spark plug strong enough the way to tell is by color and distance. The spark at the plug wire should jump about 1 1/4 to 1 1/2 inches and be mostly blue in color. If your get either of these condition from a check your found your problem . If the electrical check turn out ok check you fuel pressure normal pressure is usually 40 psi or greater . autozone may lend you pressure tester and may have a spark gap tester

Oct 04, 2010 | 2002 Ford Ranger Regular Cab

1 Answer

Car stalled. wont start back up


I would check for gas at the pressure fitting on the fuel rail for gas. Also check to see if you are getting spark to the plugs.

May 17, 2010 | 1994 Buick LeSabre

1 Answer

My Madza died while driving down th highway, felt


If you dont have much money, guessing what parts to change gets expensive. First, you need to verify if it has fuel pressure and spark, that will lead you in the direction to start looking for the problem. Pull 1 spark plug wire off and see if it will jump a 1/2" gap, If so, thats good. If no spark, make sure the cam is turning, you may have a broken timing belt.

Nov 10, 2009 | 1998 Mazda 626

Not finding what you are looking for?
2002 Mazda 626 Logo

1,099 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...