Question about 1995 Jeep Grand Cherokee

1 Answer

95 Grand Cherokee transmission runs in 3rd gear only

Transmission goes into safe mode (will run in third gear only). This problem started after I had the trany rebuilt. Trany shop said it must be an electrical problem so I took it to my regular mechanic and he has replaced the TCM twice, and gone thru everything he can think of. He says there are no electrical problems outside the trany. Returned to trany shop and they replaced all electrical components inside the trany. I drove it home, 3 miles, and it ran execellent. Later that day we drove it 1.4 miles and it went into safe mode again. The TCU/SRS DIAG fuse (10 amp) keeps burning out. Everyone is extremely frustrated! Both shops are very reputable.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 366 Answers

Blown fuse is a sign of a problem of a bad elect. circuit,grounding wire,wires touching each other,pinched wires,corrosion in elect.connection,unless its a common problem it can be hard to find!seems theres no quick fix,maybe they should refer you to some one that specializes in car elect.problems.

Posted on Mar 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Trans mode on my 1995 bmw 540i


take it to the dealer or check your trans fluid or have it se3rviced

Mar 13, 2014 | Cars & Trucks

1 Answer

1995 jeep cherokee larado wont shift to third or fourth its a 4.0


Check you transmission fluid first. This transmission has gears 1-2 auto 3 and OD 4. If you are in 3rd and 4th and it is not recognizing it, it may be the linkage or you transmission needs to be serviced. This transmission and transfer case in this year jeep if bullet proof. It is a great setup. You shouldn't have this problem unless the service to the transmission has been neglected. Pleas don't forget to rate this solution for me.

Jan 21, 2011 | 1995 Jeep Grand Cherokee

1 Answer

About 5 years ago my 95 buick skylark transmission went into safe mode for some reason. it still had park, reverse, neutral, but when put it into drive it would go into 3rd gear and stay there. It was...


Some issues with the engine or trans, can cause a third gear start (limp home mode) Dont get to happy it did not fix its self for good someone with a code reader might be able to steer you in the right direction ( A lot of codes get stored in the computer that never turn on the check ending lite ) Good Luck

Aug 26, 2010 | 1995 Buick Skylark

1 Answer

Just put another tranny in my 95 jeep grand cherokee now it wont shift out of 3rd gear what could be the problem 4.0 engine automatic


it could be a few different things? try un-plugging and plugging back in your wire connector to the transmission control module,or replace the tranny filter

Aug 09, 2010 | 1995 Jeep Grand Cherokee

1 Answer

95 jeepgrand cherokee transmission


What exactly is it doing? 1995 Grand cherokee doesn't have a limp mode for the transmission.

Jun 07, 2009 | 1995 Jeep Grand Cherokee

1 Answer

1991 bmw 520i transmission goes into 'safe' mode


quoted from BMWE34.network
" Transmission locks in "limp" mode - 3rd gear so you can "limp" home or to your nearest dealer."

"Things to check before even contemplating a transmission overhaul:
Check electrics - Alternator and battery.
Replace DME Relay and Fuel Pump Relay - not expensive.
Remove disassemble, clean and reassemble gear selector switch - If it looks beyond saving, replace ($200)
Service the transmission ($130 from a specialist) and check/replace transmission speed sensor ($90)"

Feb 24, 2009 | 1991 BMW 5 Series

1 Answer

Cherokee 1998 transmission problem


Hello
Is it the shifter not moving or is it the transmission staying in 3rd gear?
Thanks
RD

Jan 12, 2009 | 1998 Jeep Cherokee

3 Answers

Transmission


You can retrieve the codes through the OBD dianostic connector with a scanner.

Oct 11, 2008 | 1995 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

499 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60792 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...