Question about 1998 Ford Windstar

1 Answer

Oil what oil do you use for 1998 ford windstar 3.8

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 239 Answers

I would use 5w-30 anything but pennzoil.


hope this helps
please remember to rate me.

Posted on Mar 06, 2009

  • acyron May 22, 2017

    I use 15W-40 Rotilla, highly recommended, 106 thousand, purrs like a kitten.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Getting water in my oil in my 1998 windstar, why ?


This could be from a number of things. Check the seals, gaskets and lines for leaks or vacuum. Also check your oil cap.

Jan 11, 2013 | 1998 Ford Windstar

1 Answer

Oil pump


if it has more than 150,000 miles or so ---NO! only 75,000 or less YES, between that is iffy, at best. I wouldnt..

Aug 07, 2012 | 1998 Ford Windstar

1 Answer

My 2000 ford windstar...oil cap is stuck and wont come off... cap just keeps turning, what do i do?


go purchase a new oil cap the take channel locks to break off the old oil caps top part of it. Then the screwed in part can be removed next

Apr 29, 2011 | 1998 Ford Windstar

1 Answer

My 1998 windstar just lost oil presure ,all oil pressure


If the engine runs quiet the gauge in the dash or the oil sending unit is bad. generally the sender on the engine goes bad from the heat of the engine. If the engine makes all sorts of noises and rattles inside the oil pump is shot

Mar 31, 2010 | 1998 Ford Windstar

1 Answer

O2 sensors on 1998 ford windstar


1998 Ford Truck Windstar 3.8L SFI 6cyl, there are 4 oxygen sensors on the Windstars They are divided into 2 banks of 2. Bank 1 is the for the rear 3 cylinders of the engine - Bank 2 is for the front 3 cylinders. Bank 1 / Sensor 1 (upstream) is located just below, in the pipe, the exhaust manifold on the back of the engine.

REMOVE TIP: you may have to bend part of the transmission heat shield out of the way - be sure to put it back when done.
Bank 1 Sensor 2 (downstream) is located just past the drivers side catalytic converter.
Bank 2 Sensor 1 (upstream) is located just below the exhaust manifold, in the pipe, at the front of the van - access is from the top.
Bank 2 Sensor 2 (downstream) sensor is located just past the passenger side catalytic converter.

NOTES: * Use lots of penetrating oil - allow to soak - to make removal easier and avoid damaging the exhaust pipe

Hope this help; TY for using Fixya (remember rated and comment this).

Mar 30, 2010 | 1998 Ford Windstar

1 Answer

Where is oil pressure sending unit?


lower right hand side, front of engine, below the power steering bracket.

Nov 07, 2009 | 1998 Ford Windstar

1 Answer

1998 Ford windstar oil leaked out and now there is a nocking sound on the bottom of of the engine.


If you lost all or almost all of your oil and happened to start and run the engine before you discovered the oil loss,you have probably spun a bearing. It needs to be checked by a professional but you are probably in the market for another motor. Hope this helps.

Aug 07, 2009 | 1998 Ford Windstar

1 Answer

Where is the oil sending unit on a Windstar 1998 3.8 engine?


Should be close to the oil filter. It will be a metal tube sticking out with 1 wire running to a pod at the end of it.

Apr 22, 2009 | 1998 Ford Windstar

Not finding what you are looking for?
1998 Ford Windstar Logo

Related Topics:

141 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...