Question about 1995 Ford F150 Styleside Regular Cab

2 Answers

Clutch pedal stuck to the floor stick shifter will not go into gear while truk is running

Posted by on

  • 1 more comment 
  • ericmm7 Mar 06, 2009

    pedal stays up but there seems tobe alot of play and still wont go in to gear

  • Anonymous Mar 12, 2014

    Clutch pedal will operate normally over usual travel range then it becomes a little stiffer and will go to floor if pushed too hard then it sticks and needs to be levered up again.

  • Anonymous Mar 20, 2014

    Clutch Pedal sticks to the floor.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 93 Answers

Try pulling pedal up, does it drop str8 to the floor,if yes problem in hydralic clutch like clutch master cylinder or slave cylinder,if pdel stays up appears to be ok then the clutch may need replacing

Posted on Mar 06, 2009

  • myearwood0 Mar 06, 2009

    sounds like master cylinder for the clutch check fluid if ok then replace cylinder located under cluth pedal

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 182 Answers

I would check the fluid it's probably out look in the bell housing on trans you should see a plastic line going to the slave cylinder you should see the brake fluid all over if it's leaking. If not maybe the resivor

Posted on Nov 15, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can I do to adjust clutch cable on my 1989 LeBaron?


Just push and then lift the clutch pedal toward you to adjust the cable. The mechanism is above the clutch pedal and is selfadjusting as liong as you lift the pedal. If that don't work then the adjust mechanism is junk.

May 01, 2014 | 1989 Chrysler LeBaron

1 Answer

99 jetta when off stick shifter moves into different gears but when I turn the car on the stick shifter is stuck and only won't move.


Are you pressing the clutch all the way down to the floor? check your clutch peddle and go from there?

Dec 07, 2013 | 1999 Volkswagen Jetta

1 Answer

Clutch pedal is tight, stick shifter is tight. however it will not go into gear, with or without clutch pedal, and stays running, doesnt stall. new clutch three months ago


If your car wont go into gear when the engine is NOT started then you have a gearbox problem not clutch.you should still be able to get all gears without using the clutch pedal.The clutch is only there to stop you stalling when standing still,Its possible (but not nice)to drive and change gear without a clutch.Hope this helps.

Sep 17, 2013 | Mitsubishi Eclipse Spyder Cars & Trucks

1 Answer

Transmission stuck


Clutch hydraulics has air in it or the clutch master cylinder is failing.

Jun 28, 2013 | Volkswagen Beetle Cars & Trucks

1 Answer

My problem is that the manual transmission is stuck in 4th gear. I was backing up when I went to put it into 1st the shifter was stuck. The clutch works to disengage the gears but the shifter won't...


That cylinder is known as the clutch slave cylinder. It should push against the clutch fork every time the clutch pedal is depressed to allow gear changes. If it doesn't, suspect a faulty slave cylinder, or clutch master cylinder.

Sep 09, 2011 | 1999 Nissan Sentra

2 Answers

Clutch pedal sticks to the floor; the brake reservoir was low


I believe your pressure plate is broken and at a minimum will have to be replaced along with the clutch disk.

Jul 04, 2010 | 2006 Ford Fusion

1 Answer

I have a Toyota Corolla AE 100 manual gear shift gets stuck


why my 2006 corolla car gearbox is stuck in third gear and cannot move

May 29, 2010 | 1991 Toyota Corolla

1 Answer

I just got a new used 1995 honda accord and already i'm really unhappy. The gears stick terribly and the breaks... you have to push down really hard and they don't break fast. What can i do about the gears...


the gears are sticking? is the shifter just really tight and hard to move from one gear to the next, or even just wiggle around in neutral? if so, you may need new bushings for it. which are not very expensive. IF the shifter wiggles around easily in neutral, but hangs in a gear when you press the clutch in all the way, you could need a clutch, OR hopefully you can just try bleeding the clutch line. at the master cylinder on the transmission. the breaks.... do you have to push the pedal down really hard, or really soft and far? if you're putting a lot of pressure on the pedal but you don't have to push the brake pedal all the way to the floor, that would indicate to me that your pads and rotors are glazed over. you should replace the rotors, pads and have the calipers checked, and have the brakes bled. if you've got to push the pedal all the way to the floor, there's a good chance all you'll need is to have the brakes bled.

Feb 07, 2010 | 1995 Honda Accord

1 Answer

Grinding and very hard to shift, and now the shifter is stuck


how does the clutch pedal feel?..clutch out of adjustment,needs clutch job...kev-mn.

Dec 10, 2008 | 1995 Pontiac Sunfire

Not finding what you are looking for?
1995 Ford F150 Styleside Regular Cab Logo

884 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61249 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...