Question about 1985 Toyota Celica Supra

2 Answers

I have a 1994 celica and the clutch pedal keeps sticking to floor especially in reverse and have to lift up with my foot,any suggestions please.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

S check the clutch fluid in the engine compartent o thefirewall above in front of where the clutch pedal on the drivers side, also look under the dash to the pedal above to a linkage from the firewall to the clutch slave assemble, look for any brake fluid leak. Usually there is a carpet discolorization below where the leak if there is an indication of said leak. Note pay attention to detail, you also want to look and follow the lines from the clutch slave to where there is an clutch master cylinder mostly on the transmission gear housing. Note look for any leak which will be near a hydraulic line very thin metal line. Look for leaks okay.

Posted on May 23, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 1,861 Answers

Replace the clutch master and slave cylinders.
I recently had the exact same problem on my car.

Posted on Mar 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I was parked on the side of the road in my ford ranger ute for about 3 to 4 minutes with the clutch pedal to the floor i was on the phone and then i could smell the clutch burning. I took my foot off the...


The clutch might be a hydraulic system. When it's leaking oil the pedal sticks to the floor and has to be pulled back manually. Because it's designed to be fail safe, it still works but only for some time till all the oil has leaked out.

The burning smell might be clutch oil dripping on the exhaust - meaning the seal on the clutch servo is leaking oil.

There are repairkits for clutch servo's - usually it's suggested to replace the cylinder seal on the clutch pedal also.

Jul 01, 2011 | Ford Ranger Cars & Trucks

1 Answer

2001 prado. clutch pedal sticks to floor under pressure, l can lift it with my foot and carry on driving. Pedal often sinks to the floor on its own. Slave cylinder issue?


may have a large leak in the slave cylinder. do you see fluid dripping underneath te transmission housing? it could have an internal leak but not as common. check the fluid level in the little reservour on the firewall.

May 26, 2011 | Toyota Land Cruiser Cars & Trucks

1 Answer

The gears are incredibly sloppy in my toyota celica 90' , some friends have suggested that it is just an adjustment with the clutch, as the clutch is on the floor, where is the adjustment? Imogen


make sure you don't have a leak in the clutch master or slave cylinder on the transmission as that would cause the pedal to go all the way to the floor. Check your clutch fluid level, then go back inside the car and look behind the clutch pedal like up towards the top of the clutch rod right by the firewall. You will see and adjustment nut, although I doubt that the adjustment is the problem. How long have you had this clutch in? You may need to have the clutch replaced.
syncrswim_2.jpg

Nov 25, 2010 | 1990 Toyota Celica

1 Answer

Started off with cluth sticking to floor.would have to pull clutch pedal back up with foot. truck would stick in gear. even with clutch fully depressed. seemed like spring had disconnected from clutch...


your clutch uses a hydraulic master and slave cylinder to disengage. It is likely that the slave has been leaking and the reservoir gone dry, thus allowing air into the system and reducing effectiveness. Check the clutch master cylinder reservoir (near the brake reservoir) fluid level. If low, also check the slave cylinder at the clutch for leakage. If leaking, replace the slave and bleed the system. If you need procedures or have more questions, please let us know.

Sep 25, 2010 | 1994 Nissan Pickup

2 Answers

Clutch pedal sticks to the floor; the brake reservoir was low


I believe your pressure plate is broken and at a minimum will have to be replaced along with the clutch disk.

Jul 04, 2010 | 2006 Ford Fusion

1 Answer

Clutch sticks when pushed to floor


a clutch pedal that doesn't return back to you is sometimes a symptom of a failing clutch slave or general fluid leak. This is of course referring to a hydraulic clutch. If your fluid gets too low or there is an air leak your pedal will stick to the floor and not return.

Oct 26, 2009 | 1994 BMW 3 Series

2 Answers

I have a 2001 Jetta VR6. The clutch has very little play


so it engages at the end of the push or just when your foot is about to leave the pedal if it is all the way to the end when your foot is down to the floor this could mean that you have a leak in your slave cylinder or the clutch is just about to the end of its life. repair would be replacement.

Sep 09, 2009 | 1994 Volkswagen Jetta

1 Answer

Clutch switch


its on ur clutch pedal

Apr 03, 2009 | 1994 Honda Civic

1 Answer

The clutch on my car stuck to the floor. I check the reservoir was completely empty. I have a feeling the slave cylinder is filled with air. I'll need to get the schematics to see how to bleed the...


lift the pedal manuelly up fill the reservoir on the trasmission on the side near radiator the cylinder there. there a bleader on it open it the oil will come out by gravety its brake oil dot3 that goes in it keep filling the revervoir after a few minute close the bleeder and go pump the clutch pedal many time try it out pierre

Aug 17, 2008 | 2005 Chevrolet Cavalier

Not finding what you are looking for?
1985 Toyota Celica Supra Logo

454 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...