Question about 1998 Chevrolet C1500

1 Answer

98 chevy pickup headlight replacement instructions: Where do I start? Where is it bolted to the frame?

Posted by on

  • tjr57 Mar 19, 2009

    Great advice, just like you described.

    It was very helpful.

    Thanks

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

There should be two long silver colored bolts sticking up from the headlight from behind the grill when you open the hood. They should have small heads, about 7 or 5.5 mm. Remove these bolts(studs) and the headlight lens will pull out the front.

Posted on Mar 06, 2009

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the bed of a 98' Chevy S10 step


disconnect all electrical connections between the frame and box, disconnect the fuel filler hose from the box or the fuel tank, there are 4-6 bolts that mount the truck bed to the frame to remove. move truck bed.

Sep 25, 2014 | Cars & Trucks

1 Answer

1993 chevy silverado parking lamps go of when i turn on headlights, signal lights flicker when i press on brake.


Yes I would look for a ground circuit problem. I would look at the ground wires for the headlights first. Even run a new ground wire for the tail lights to see if it helps.
Could be a ground connection for the body to frame or body to battery.

Aug 10, 2012 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

My headlights have quit working on my 1994 Chevy 1500 pickup. I replaced the headlight switch but they still don't work. The parking lights come on but not the headlights


Try checking both a; your fuses, and b; check your bulbs. You should have two fuse boxes, one under hood and one in or under the dash. Check those for bad, blown or weak fuses. And check your headlights bulbs for them being good and their connection. If this doesn't fix your problem, you may check out your highbeam switch.

Dec 31, 2011 | Cars & Trucks

1 Answer

Put new fuel pump, fuse, and relay in 1998 chevy s10 and still no power to fuel pump


Did you check the ground wire on the frame. There is a ground wire that is bolted to the top frame rail near the left rear wheel opening. I've seen that wire break or get corroded where it bolts to the frame. I'm not sure of the location on a 1998 but that's where it is on the earlier models as well as the full size trucks. That wire also grounds the gas gauge, does the gas gauge read goofy? Also keep in mind the pump only runs for 3-5 seconds then it shut off, until the engine starts, or the starter is engaged. Good luck!

Dec 20, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Will the bolt pattern on rims off a 98 Jeep Wrangler fit on a 98 Chevy S-10


Sorry no they won't fit. S10 are 5 on 4.75 positive offset. You can put older wheels from many older chevys on them but they will stick out of the wheel wells if you have 4x4. The Wrangler are 5 on 4.5 negative offset.

Nov 04, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

98 Chevy Pickup. Alternators keep blowing. about 3 starts and they are only putting out about 10.5 to 12.0 volts.


you may have a short. i would probably check the ground strap from the engine to the frame. they can rot out. my 98 chevy is garage kept with 65000 miles and it looks terrible. the rest of the truck looks new. other than that. make sure the battery is good. and possibly take it in and get it checked before more damage happens.

Sep 28, 2009 | 1998 Chevrolet K1500

1 Answer

Automatic headlights not comming on


Bad connection to the light sensor which will no doubt be mounted on top of your dash?

Sep 05, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

98 chevy s-10 2wd is it possible to change the oil pan gasket without pulling the motor? can i just pull the mount bolts and jack it up?


Yes it is possible but you will have to get about six inches of clearance so the pan will clear the oil pump pickup

Jun 22, 2009 | 1998 Chevrolet S-10 Pickup

Not finding what you are looking for?
1998 Chevrolet C1500 Logo

Related Topics:

997 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...