Question about 2006 Jeep Wrangler

1 Answer


Posted by on

  • 2 more comments 
  • stephencu120 Mar 11, 2009


  • Richard Scordino May 11, 2010

    Can't be too quick if it won't start! Unclear as to if engine is cranking or if starter will not turn engine.

  • Toyota Guy
    Toyota Guy May 11, 2010

    Does it turn over?

  • Henry KAo May 11, 2010

    Yes there any check engine light?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Check block ground at end of battery cable. Make sure it's clean on the contact surfaces. do same with body ground. Check voltage at the starter. Should be 12v at large cable, 12v at small cable with key turned to start. sorry for the comment before but it was too hard to let it pass! Check back and tell me what you find after testing!

Posted on Mar 11, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Did I damage truck by trying to jump start?

Try unhooking the battery it does a sort of reset. And check fuses all fuses and relays

Dec 07, 2016 | 2004 Chevrolet Silverado

3 Answers

Replaced the battery and alternator, battery still dies

ok so your acid level in the battery needs to be checked if its at the right level get another battery because there are dead cells in it. if the alternators good check it to be sure even new parts can be bad. ok same problems with a good alternator bad battery. Hope this helps

Feb 19, 2015 | 1999 Chevrolet Blazer

1 Answer

I have a 1995 geo metro notice my dlr lights not working and the car wont star it wont even click or turn the motor all the fuses are fine and when turn the switch to on position engine light come on

head lights must come on, or the battery is dead.!!!
the head lights work key off. so that is first check, and first to fix.

when this happens you have a dead battery, (fuses good, and tested all fuse,in engine bay.
  1. the classic, jump start using jumper cables .
  2. charge the battery so it reads 12.6vdc rested
  3. try a known good battery in car, that works in another car.

easy, right?

Feb 17, 2015 | 1995 Geo Metro

1 Answer

My mg zt v6 2.5l auto will not start, no fire up just completely dead now

check your battery connections and for a good ground check battery voltage

Apr 14, 2013 | Cars & Trucks

1 Answer

Just brought 2000 chevrolet venture van have fuel pump isseu but not pump i checked fuse box someone have a small black wire connected to fuel pump fuse and fuel pump relay that blow so i replace both...

It's possible someone used the jumper wire to load side of fuel pump relay, gray wire. That supplies voltage to fuel pump motor, the fuel pump fuse is hot all the time. The fuel pump will run all the time even with key off, running down the battery. They used the jumper because of some kind of problem. Can you unplug the relay and check relay terminals, where the relay plugs in. Use a test light, either a problem on the load or control side of relay. Are the relay terminals numbered, like 30 and 87, maybe 85 and 86 also?
fuel pump-hf4vnnakl4ax4mbzgtumbmbo-1-0.jpg

Sep 06, 2017 | Cars & Trucks

1 Answer

Battery keeps losing voltage

Before going to procedure below, lightly rap on all relays with a screwdriver handle, a sticking relay can cause all kinds of problems.
Here is the test procedure for determining battery or alternator problem after requiring a jump start. Note, requires a voltmeter [$3.50 at Harbor Freight]
1] Check battery voltage on non-start vehicle. Will probably be under 12V. Verify good clean connections, look for cracked corroded or loose terminals.
2] Jump start. Note, always have the jumper vehicle running when performing a jump start, sounds basic but I actually had a friend who argued it should not, meaning he would be jumping with less voltage & could strand both vehicles.
3] With jumper cables removed, engine running, check voltage at battery. It should be 12.8V to 13.7V. If below 12.8V the alternator or voltage regulator are suspect. If in the range, the battery is either dead, low on water or in need of a full charge. If over 14.7V the voltage regulator is not functioning properly.
4] Failing those problems, with the vehicle shut off & the doors closed, disconnect the battery ground cable, put a 12V test light between the battery negative & a known good ground. If it lights, something, like an interior or glovebox lamp, is staying on. Remove fuses 1 at a time to find the problem circuit.

May 22, 2012 | 1998 Ford Taurus

1 Answer

My 2000 300m has been sitting for 7 months without being started and the battery went dead during this time. it was running fine prior to sitting. I tried to jump start it and it would not start, I saw...

There has to be a code store in the computer that will tell you what might be wrong. the code is the place to start. My 99 sat for a year, and after recharging the battery and getting it started the only code I could get though, was the dead battery or disconnected battery code- but the point is, it started. Check for mouse-eaten wires at the cam sensor and the Crank Sensor. Hey- it could happen...

Oct 30, 2010 | 2000 Chrysler 300M

1 Answer

My car is fine when i jump it. but if i shut it off and turn it on SOMETIMES it will be dead. i went to autozone when it started and had it checked and the check said everything was good but i continue to...

It sounds like you need to take your battery terminals off and clean your posts and terminals.Sometimes the simplest things can stop you in your tracks. The Autozone should have been able to tell you what the code meant. If your battery is going dead but your alternator and battery are good. Carefully check your fuses . not the regular ones , the block fuses . You could have an alternator fuse that is blown. Even though everything is working the juice just is not getting to the battery. The charge light on the dash may not tell you if the fuse is blown.

Sep 14, 2010 | 2004 Suzuki Aerio

1 Answer

97 toyota avalon was running went dead while driving ,now wont start lights go dim,abs light and traction lights come on when jump started

Sound like you have a bad alternator, poss bad battery too.If you can jump start it with a volt meter check voltage at battery should have above 13.5 volts, do this after you unhook jumper cables and engine running.If bad voltage reading replace alternator make sure you charge battery before starting engine with new alternator or it could damage alternator.If good voltage have battery check.Hope this helped.

Nov 25, 2009 | 1997 Toyota Avalon

Not finding what you are looking for?
2006 Jeep Wrangler Logo

51 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides