- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Are you referring to the SPARK plugs? The Mirage's 1.8 engine does not use standard spark plugs, because it is fuel injected. It uses 4 fuel injectors that has gas hookups & electrical hookups. They are located on the head in the back.
There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!