Question about 1993 Jeep Grand Cherokee

2 Answers

1993 JEEP GRAND CHEROKEE LAREDO IM TOTALLY BAFFLED

1993 JEEP GRAND CHEROKEE LAREDO- TRUCK WONT START GOT FUEL IN FUEL RAIL GOT NO SPARK BUT ROTR TURNS AND I HAVE JUICE COMING FROM COIL COULD IT BE CONTROL MODULE AND IF IT IS WHERE IS IT LOCATED ON TRUCK THANKS

Posted by on

  • boomdboom121 Mar 24, 2009

    I have the same problem but I have no spark from the coil wire to the cap. I have power going to the coil through one of the two wires leading to the coil but nothing after that. I have plenty of fuel pressure. Over the last 2 months the truck has been taking longer and longer tokick over when it's cold.

  • Anonymous Mar 14, 2014

    1993 pontiac grand am wont start when warmed up. and the fuel pressure is okay

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Back up a minute...Do you have spark from the coil wire? (juice from coil) If so, change or check rotor and cap (wires do not all go bad at same time so unless they are wet, likely at least good enough to start engine)

Posted on Mar 05, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had this problem on my 1993 grand cherokee check your crank shaft sensor

Posted on Aug 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1993 Jeep Grand cherokee laredo with the 4.0 its starts for only a few seconds and dies changed the fuel pump and fuel filter and the sercurity light doesn't come on im stumped any help ?


Check the crankshaft position sensor, i have repaired 3 Jeeps (after the owner spent a lot of time and money replacing fuel pumps,TPS, and many other items) then got frustrated, brought it to me and within an hour it was running fine with a new CPS

Apr 04, 2013 | Cars & Trucks

3 Answers

I have a Jeep grand cherokee laredo and i have installed a new fuel pump and fuel filter but it will not start i have checked all fuses and relays please help.


Having same issue with my 2000 grand cherokee. sometimes fuel pump will prime and car starts the other 50% of time no fuel pump noise only smaller radiator fan will come on and make vibrating whining noise. I have changed out fuel pump and filter as well as checked and ruled out all fuses/relays involved. Need help too

Aug 04, 2010 | 2000 Jeep Grand Cherokee

1 Answer

How to change fuel injectors in a 2000 jeep grand cherokee laredo 4.7L V-8


Hi, you have to remove the fuel rail and then remove the electrical connector and then there is a clip that holds the injector to the fuel rail remove that clip and then remove the injector

Nov 10, 2009 | 2000 Jeep Grand Cherokee

1 Answer

Wont start 1996 jeep grand cherokee laredo inline six4.0 fuel inj


The first thing I would do since you think it was flooded is to replace the sparkplugs, sometimes if a spark plug has been washed out with gas you cannot get it completely dried out. After you replace sparkplugs try to start the engine. If the engine starts I would still recommend that you change your oil because of fuel saturation. If your engine fails to start I would suspect that you have a bad crankshaft position sensor as it is known to give problems. The crankshaft position sensor is located on the top of the transmission bell housing on the drivers side.

Oct 02, 2009 | 1996 Jeep Grand Cherokee

1 Answer

1993 JEEP GRAND CHEROKEE LAREDO- TRUCK WONT


OK...I have a 93 outside...one diagram I have shows an ignition module next to coil...but there is none on mine, (4.0 engine)
Two items to check are crank sensor and cam sensor inside distributor. Test procedure can be found in just about any manual including haynes.
You will need a decent volt/ohm meter to do testing. You can also check codes by turning ignition switch on/off three times, leaving it on the third time. Check engine will flash code #'s (ex: one flash, pause two flashes= the number twelve.then followed by a longer pause then another set of flashes etc.)

Mar 05, 2009 | 1993 Jeep Grand Cherokee

2 Answers

99 grand cherokee laredo wont start but turns over


Check power to the ignition coil,,you may have interfered with one of the wires going to the coil

Jan 16, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
1993 Jeep Grand Cherokee Logo

Related Topics:

703 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...