I need an assembly diagram for the trunk lock assembly from a 2001 volvo S40. THe trunk wouldn't open, so I pulled the lock assembly out. I found which bit was broken, but I don't know what the piece looked like originally.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
This is a diagram of the lock assembly in the trunk lid. The highlighted area shows the lock in the open position. If you look at your lock assembly and it doesn't look like this, it may be in the locked position causing the trunk to not close. use the trunk key and turn the lock cylinder. You may have to use a screwdriver to gently pull on the lock hasp while using the key to unlock. If the hasp is in the locked position, it should open and allow the trunk to close properly
try having someone jiggle the trunk up and down from the outside while you pull on the emergency release from the inside, you may have a problem with the wiring in the trunk itself, the wires have a problem chaffing where they come out of the trunk lid and go into the car, you can disconnect both ends and replace that for about $30
If it is the same as the 2007 model.
The top of the key is a small slide switch.
You slide it and pull a vanity key out.If the glovebox has been locked it also possibly locks the boot with the same switch.
You will probably need to put key in glovebox lock and turn counter clockwise.
That key is to lock the seats to stop anyone getting into the boot via the fold down system as well.
My apologies for the delayed response. I am going back and answering questions that were never answered. Clickon the following Link. It has all the Diagrams for the Timing Belt you will need. Before Clicking, let me know if this helped. Again my sincerest apologies...
to put on a trunk lid is very simple usually 4 bolts on the bottom near back window. As far as locating a trunk lid look under auto salvage in the yellow pages tell them what you need they can locate the part for you over their network. Anyone with a wrench will be able to install the lid as long as there is no other body damage
you'll need to insert your key into the trunk lock. prior to doing this you'll need to use the automatic lock on the driver side of the vehicle, hit the unluck button twice. Torn the key in the trunk to the left, you may have to slightly press the trunk button in while doing this and give it a lttle wiggle after the key has been turneed to the left push the button all the way in, if this does not work repeat the process but reverse to the right instead of the left.
This manually disables the remote lock for your trunk.
hello theres really not many choices if you have a trunk key it should work if not and the inside trunk release isnt working either you could try to get at the lock setup from the back seat take your lower seat out remove the lower holding bolts slide up off the top lock setup see if theres enough room to work from there to pop the trunk open with a flash light and a screwdriver if not your going to have to pop the lock cylinder at your trunk once its out you can get a aftermarket replacement under $ 20 goodluck please rate