No gauges on the dash work - 1998 Mazda Protege

Dash lights and gauges should be located in the fuse box under the instrument panel.

Use scan tool to view rpm when dash gauge is not working.If rpm is showing on the scan tool when dash is not showing prm,it is a good bet dash gauge or connections at gauge cluster are defective.

None of my gauges will work, but my turn signal indicators ...

www.americanautowire.com/.../none-of-my-gauges-will-work-but-my-tu...

None of my gauges will work, but my turn signal indicators, high beam ... As we've discussed previously, anything electrical needs a 12 volt feed and ground to work. ... 09/28/2015 There are a number of new products coming in Nov/Dec this ...

my gauges quit working - CarGurus

www.cargurus.com > Questions > Ford > F-250 Super Duty

CarGurusSep 21, 2013 - my gauges quit working - My odometer, speedometer, fuel, tach, trip, and ... I tried fixing the wire and had the same problem....so I replaced the shift lever and everything is back to ... no gauges will work in dashboard 1 answer.

No dash gauges, but dash lights - Car Forums and Automotive Chat ...

www.automotiveforums.com > ... > Dodge > Caravan ' Voyager

Feb 6, 2010 - The dash lights work fine, so does everything else. The dash gaugesjust don't work. This is something that has been an intermittent problem ...

tap the dash see if it comes back on. if not the control in the dash board may have gone. or push on the dash if it works then its not sitting propper to the plug on the back of the dash.

You don't say what the make model and year is, but generally the gauges get power from the same place the gas gauge does. Each gauge is grounded thru a sending unit or switch.
So my guess would be a problem inside the instrument cluster.

Likely, it's the sender unit in the tank. To check wiring and your dash gauge, you can pull apart the connector at the fuel tank, find the wire for the gauge sender unit (its color coded-I dont kinow what the one for your car would be), and on the harness side(the one going to front of vehicle) use a jumper wire and ground that wire to the car frame(get me? you want to ground the wire going to your dash gauge)-with key on, your gauge working properly will move up to half-way or even full. That tells you your dash gauge is working and your wiring to gauge is good. If gauge doesn't move when grounded(double check for a good ground), then your dash gauge may be bad.

Dam you need a EXORCISM!
No just a loose connection in the dash.
Sounds easy right!
IF you are lucky it may be the main plug not seated into the dash board. Or a bad ire in that connector.

You need to check your main fuses under the hood first and then check them under the driver side dash board.

temperture gauge is not working and dash sign comes on says turn off e/c e/c is on , but the temp gauge doesnt work

Behind the dash is what they call a constant voltage regulator. It controls the guages. It's small and located behind the dash near speedo.