Question about 2000 Mazda Protege

1 Answer

No power at the port where scanner is plugged into. how can I regain power

Posted by on

  • yadayada
    yadayada May 11, 2010

    is this a car related question??

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Check fuses--if not could be prblem with pcm

Posted on Mar 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Pontiac g6 ecm port under the dash, when code reader is plugged in it gives a link error? Any ideas what to troubleshoot


is your code reader "can" ready? the newer cars communicate to scanners using different protocols and your scanner may not have that protocol. have you scanned the vehicle using this scanner before? also check fuses as most manufacturers use the cigaret lighter fuse to power the "dlc" data link connector.

Jun 09, 2011 | Pontiac G6 Cars & Trucks

1 Answer

Why would I be getting poor gas mileage on a 2000 vw beetle? I just bought with 68000 miles


well you could need a tune up new spark plugs wires , or coil on plug depending on vehicle change oil and air filter pcv valve check tire inflation level add air if needed also try adding a regaine fuel system treatment regaine isolates ethenol aka water and passes it though system and cleans injectors lits ports ect

May 05, 2011 | 2000 Volkswagen Beetle

1 Answer

Can,t get my obd 2 code scanner to connect with the port under the dash


check that the obd2 port has a good ground and the power pin is powered. also make sure the car is running before you plug it in. some readers only work while engine is running

May 28, 2010 | 2006 Toyota Corolla

2 Answers

Ecu plug won't work.


did you turn the key too the acc position after you plugged it in? But dont start it.

May 07, 2010 | 2000 GMC Jimmy

2 Answers

Engine light came on kia 2007 rondo


you need to have the code read to see what it is most auto parts store can do that for free that will help use tell you what it is

Mar 03, 2010 | 2007 Kia Rondo LX V6

3 Answers

Hesitation under load ,creating a misfire code that clears in three drive cycles


I belive the dealers have a T.S.B. ( tech service bulletin) on a issue close to this. I belive they re flash the ecm as the repair. Just thought you might check into it. Hope this helpes.

Aug 14, 2008 | 1998 Chevrolet Tahoe

Not finding what you are looking for?
2000 Mazda Protege Logo

Related Topics:

60 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

60541 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...