Question about 2006 Ford Focus

1 Answer

Ford focus spec

Does my ford focus 1.4lx 56 plate have an alarm fitted as standard?
many thanks,david.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 126 Answers

It has a vehicle anti theft system or vats system with out the factory programed key it will not start .

Posted on Apr 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Ford focus 1.6 56 plate. one of the screws holding the coil pack is becoming difficult to remove and i want to replace it. any ideas on the thread type/size? where can you buy them

From a ford parts counter or a local Motor factors. When you refit the new one, smear some copper grease on the threads, this will prevent the dissimilar metal corrosion.

Aug 24, 2013 | 2005 Ford Focus

1 Answer


On this forum the "Focus" model has the most problems.

I would check consumer reports, or try some of the Focus forums.

Jun 18, 2013 | Cars & Trucks

1 Answer

Dash board lights on after fitting stereo in 56 reg ford focus

you have connected the wires to the wrong cables ,either buy a proper fitting kit or run your own wires direct .

Nov 27, 2010 | 2006 Ford Focus

1 Answer

Ford Focus 56 plate windscreen washers Water only just coming out of front, and nothing from rear. The reservoir was allowed to run dry, which according to the manual, should not be allowed to...

Sounds like you have a failed one way valve it's built inline with the washer pipe. It stops water from flowing back so it doesn't take ages for the washers to work. There is two of these behind the drivers wheel arch liner and one on the osr of vehicle trace the pipe bk to fine the valve. Remove valve and fit a piece of pipe on it's place job done!

Oct 06, 2010 | 2005 Ford Focus

1 Answer

Speedo problem

Just fit a new speed sensor on the gearbox.Its location is on the output shaft side of the box.Thats your problem a faulty switch.Good luck pippall

Aug 08, 2009 | 2000 Ford Focus

2 Answers

Fitting an isofix car seat in a ford cmax 57 plate tdi

if there are a small part of the backseat (ca 10 cm high located at the bottom of the back) that can be picked out, you have isofix points.
if your backseats are in one pice, theres not

Apr 11, 2009 | 2007 Ford Focus (3 Door) Hatchback

Not finding what you are looking for?
2006 Ford Focus Logo

Related Topics:

287 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5623 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides