Question about 2000 Audi A4

1 Answer

Where do i find the starter motor in my audi a4 w reg

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 47 Answers

This is info i pulled but not sure exactly what engine you have...here are a couple though
REMOVAL & INSTALLATION



Fig. After the negative battery cable is disconnected, remove the wire terminals from the starter solenoid



Fig. Remove the lower starter mounting bolts . . .



Fig. . . . followed by the upper bolt, then remove the starter from the transaxle housing



where do i find the starter motor in my audi a4 w  - 0900c152800c2ab1.jpg enlwhere do i find the starter motor in my audi a4 w  - enlarge_tooltip.gifs=enlarge_tooltip.gif Fig.where do i find the starter motor in my audi a4 w - 0900c152800c2ab2.jpglocations-1994 2.0L, 2.0L ABA



0900c152800c2ab2.jpg enlarge_icon.gifenlarge_tooltip.gif Fig. Remove the upper starter bolts



Fig. Mark the location and length of each starter bolt

Fig. When the solenoid is energized the starter drive is pushed out and meshes with the flywheel to crank the engine

  1. Note the radio security code, and then disconnect the battery ground cable.
  2. Raise and safely support the front of the vehicle with jackstands.
  3. If installed, remove the lower engine shield.
NOTE
The engine must be supported on 1990-97 Passat models as the starter mounting bolts also support the engine-to-transmission mounting surface. If necessary, label the small wires before disconnecting them.

On 1990-97 Passat models:

  1. To support the weight of the engine and transaxle, install the engine support Tool Nos. 10-222A and 10-222A/1, or use a floor jack (with a block of wood on the chock) to support the engine by the oil pan. Do NOT jack the car by the oil pan under any circumstances! The floor jack is ONLY to support the engine while the starter is being removed. This is necessary because the bolts that secure the starter to the transaxle are also used to secure the front engine mount to the transaxle.
  2. Disconnect the large cable, which is the positive battery cable, from the solenoid.
  3. If equipped, remove the bracket that secures the starter to the engine. On Audi A4 and 1998-00 Passat models:

Release the number 50 electrical connector from the starter.

  1. Then remove the nut for the large battery cable and remove the cable.
  2. Loosen then remove the clamp that secures the heat shield to the starter.
  3. Remove the fasteners securing the bracket at the front of the starter and remove the bracket.

Remove the starter mounting bolts, while supporting the weight of the starter.

  1. Pull the starter straight out from the transaxle. To install:
NOTE
On vehicles with a manual transaxle, there is a bushing where the starter shaft fits into the bell housing. If the shaft or bushing is worn or if the starter has been jamming, the bushing should be replaced. There is a special bushing removal tool available but a small inside bearing removal tool is usually sufficient.
Install the starter into the transaxle.

  1. Tighten the related starter motor fasteners as follows:
  2. Starter support bracket, M5 nut: 35 inch lbs. (4 Nm)
  3. Starter support bracket, M8: 16 ft. lbs. (22Nm)
  4. Battery cable to solenoid, M8 nut:10 ft. lbs. (13Nm)
  5. hydraulic hose support bracket, M8: 84 inch lbs. (10Nm)
  6. Starter mounting fasteners, M10: 44 ft. lbs. (60 Nm)
  7. Starter mounting fasteners, M12: 48 ft. lbs. (65 Nm)
  8. The balance of the installation is in reverse order of removal
Check out these third-party site for more info. Yeah, we're nice like that.
AUTOBATTERIES.COM
GILAFILM.COM-->

Posted on Jul 09, 2009

1 Suggested Answer

chain saw
  • 94 Answers

SOURCE: w reg audi wont turn over after fitting new starter motor

IF YOUR ENGINE WON T TURN OVER AFTER YOU FITTED A NEW STARTER MOTOR..I WOULD START WITH THE BATTERY MYBE DEFECTIVE NOT HOLDING FULL CHARGE....THEN CHECK WIRING.....GET BACK TO ME IF YOU NEED MORE HELP !!

Posted on Mar 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i replace my heater motor on my audi a4 19 tdi (1999) T reg ?


It is a long and involved job Give yourself about 14 to 18 hours total plus parts and coolant.

FYI : Take lots of pictures with a digital camera as you dismantle the dash and center consul so you can see how it was before you forgot how that part went in !!

Sep 03, 2011 | 1999 Audi A4

1 Answer

How manny litres of petrol dose the petrol hold on an Audi A4 P reg 1.8li


Petrol tank capacity:
1997 Audi A4 FWD: 16.4 U.S. gallons = 62 litres
1997 Audi A4 Quattro: 15.9 U.S. gallons = 60 litres

Aug 20, 2010 | 1997 Audi A4

1 Answer

Lost radio code for 2000 audi a4 concert radio need to find code reg FHZ4988


Unfortunately Audi codes are very secure and only available from your Main AUDI Dealer or a Radio Decoding Service

Jun 04, 2010 | 2000 Audi A4

1 Answer

Where is starting motor on audi a4 p reg


The starter motor is placed on the right bottom side of the engine (on the passenger side), and it is mounted on the clutch case & cylinder block.

Mar 01, 2010 | 2000 Audi A4

1 Answer

Hey there, I have a P reg Audi A4 avant sport. The initial problem was that the ignition key did not spring back from cranking the starter motor, I believe this has caused my bigger problem which is that I...


It sounds like you have 2 problems.

The first is the ignition switch. Call or visit your Audi dealer and ask about a recall for your ignition switch. I believe it should be replaced under recall.

Next, it sounds like the starter solenoid is not engaging. The starter has probably been damaged due to the faulty switch.

The third, and I hope it is not the case, is that the teeth on the flywheel which engage the starter are damaged and missing.

Once the starter is removed it will be obvious if there is damage to the flywheel.

Good luck.

Dec 14, 2009 | 1998 Audi A4

1 Answer

Cant find fuse box


For Audi A4 2000 the fuse box is located on the left side of dashboard behind a plastic cover (for left hand steering wheel vehicle). On inner face of the plastic cover you will find the fuse diagram. Please Rate my Respone! Thanks!

Oct 01, 2009 | 2000 Audi A4

1 Answer

Just bought audi a4 tdi w reg cant input anything


try puling the fuse out of the back of the radio and then letting it sit for an hour then you have to push a sequance of buttons to put the radio code in so it will unlock

Sep 17, 2009 | 2000 Audi A4

1 Answer

Audi A4 starting problem


your have a bad starter relay look at owner manual for location and replace

Apr 21, 2009 | 2000 Audi A4

1 Answer

W reg audi wont turn over after fitting new starter motor


IF YOUR ENGINE WON T TURN OVER AFTER YOU FITTED A NEW STARTER MOTOR..I WOULD START WITH THE BATTERY MYBE DEFECTIVE NOT HOLDING FULL CHARGE....THEN CHECK WIRING.....GET BACK TO ME IF YOU NEED MORE HELP !!

Mar 15, 2009 | 1998 Audi A4

1 Answer

97 audi a4 no power/battery fuse?


Sounds like either the battery leads are on the wrong way round, or the starter main cable is touching something and shorting to earth. Retrace your steps and check your connection locations.
Either that or its a dead short through the starter. Remove main cable from back of starter and tape up incase of short. then reconnect battery. If ok now then your looking at starter motor.

TL

Jan 01, 2009 | 1998 Audi A4

Not finding what you are looking for?
2000 Audi A4 Logo

2,543 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

61168 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

13152 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...