Easy problem to solve. open bonet look at bottom of wind screen you may have to take plastic cowl of wiper linkage. 3screws. linckage will have jumped off ball fixing . put some grease on ball slip on linckage will be tight but will go on job done.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
BLOWER DEAD IN DASH.
the blower must blow, or AC can not run, by laws/rule of ICE UP)
so blower is first, for sure hot outside is it car run drives great?, and head lamps ok key off and key on?
2012 cars here USA, (we have no kangoo) all have lots of computers, in the car, and one called BCM runs most of this.
BCM means BODY BRAIN, a huge job that covered in the service manual.
We test all fuses after they kinda look ok, viewed. (meter tested !)
we next scan all PCM/BCM at the DLC scan port. or Fail
cars with any kind of EFI, electrical or transmission problems
must be scanned, or go broke GUE$$ing.
blower on High must work.
be best to diagnose that first.
what does DISPLAY bad mean?. where is it? the IP cluster, NAV or RADIO LCD?????
when cars fail
tell all that works or fail, not just fails.
see?
Hi,
The wiper could have a problem on fuse and the switch, check that!
The reverse light could be the bulb connection, fuse, and the reverse switch that is located on ur transmission( connection wire could have been disconnected or the switch malfunction ).
No! The service light will not and cannot be activated by these problems!
Go to ur favorite electrical technician and have him check on it!
Thanks for asking FiXYa!
i Just fixed a problem with a renault megan washer motor. If the motor makes a noise but is not pumping any water & the jets@ the windscreen are clear, then pull the suqirter motor out off the washer bottle( the bottle stays in place ) it just pulls out from underneith the bottom stone tray& may need to remove bottom bolt, inner lower wheeel arch. Right Now where the black & white squirter come out of the motor gentlywith a screw driver pop these off together. ( test motor again) ( put in water ) Then with Snap ring plires & part the white & black outlets apart & you will find a rubber seal that looks like it must of grown. When it grows it blocks both ports off. you need to shorten the rubber & keep it flat as remember its job seems to block off either the front or rear port. if it not a good finish you may get water coming out of the front & the rear ifeg your working the front squirters
if the fuse is fine then get a voltmeter and test the voltage reading to the wiper's electric motor.If you get a reading then check the motor itself as it may be faulty.
Most cars turn on the wipers when the washer pump is turned on. Look for a stuck switch or relay in the washer circuit. It seems that the wipers think that the washer is on.
HI
Well im a girl and know nothing about cars and just had a nightmare with my wipers. Went to 3 garages yesterday who checked the motor and fuses and they were fine. They all said it was the wiper relay which I have had to order from Benfield motors-they are now selling the parts for renault...they didnt have a clue to be honest! The lads in Kwik Fit have been amazing and very helpful! Hope this helps. I am waiting for my relay to be delivered...so fingers crossed!!
×