Starter motor strter motor just clicks and does not start is it time to get rid off it when i get it fixed

all starterts are where motor block meets the gearbox,they have a big wire to the chassis or the negative and one to positive,causion,if u mess arround better disconect the battery,short is very dangerous in this case.strter have a lock on the body that action like a relay,if u dont have a clue about electrics don,t mess arround,best try a push start but than again,if u don,t know what ur doing it may turn ugly,and drive to the first garage

Inspect the flywheel, Remove the starter and turn the engine with a socket from the front damper while checking the flywheel for missing teeth. Also check that is not cracked.
I hope this helps!!

Are you saying the engine is difficult to crank, or start ?
If it cranks ok but takes a long time to start, the starter is not the problem. You would look at ignition or fuel.

first disconnect batterythen disconnect wires from starter. should be only to bolts holding it in place...Hey you done it...hope this helps and good luck...Please rate my post.

Hi,
U have to bring ur starter motor to ur garage and have them check the carbon brush and the solenoid cap.
Not enough current is going to the motor starter!

Yes it ticks when battery can not turn the starter

just replace starter But charge your battery since it has been worked very hard

You need the solenoid switch either replaced or repaired.The solenoid is part of the starter and the Nippondenso brand can have the contacts replaced in it and the Mando brand is only serviced by replacement.Either way,it will be a lot cheaper to fix the solenoid switch then to replace the starter,but a new starter will also get rid of your problem,hope this helps!

need to check the main wires try putting a jump lead on the pos battery and then to strter to to see if it turns over if does then some thing wrong with wiring

either the starter gear is bad or there is a bad spot of gear on the flywheel. the strter will need to be removed and the starter gear/ flywhell inspected.

Check your cables and the ground 's connections especially. Make sure the terminals are clean and well-tightened.

Hope this helps,
matt