Question about 1996 Honda Accord

1 Answer

Which line to put 134A in for air condition? - 1996 Honda Accord

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 110 Answers

They are two fitting depending what year this car is? this car should have one red cap ( small port) blue cap ( big port ) you will want to use the big port. if the vehicle came from the factory with r134a in it then the hose will only hook up to the charge port so you cant really go wrong there. just dont over charge the system and check for leaks after your done

Posted on Mar 04, 2009

5 Suggested Answers

davesmith_37
  • 94 Answers

SOURCE: 2000 chevy tahoe air conditioning blowing warm air

probably a leak.

what are your high and low side pressures?

Posted on Aug 01, 2009

  • 62 Answers

SOURCE: Rear air condition is not working, only the front

No there is only one low and one high side service ports.You have a bad expansion valve on the rear a\c unit.To properly replace the valve,you must first recover the freon from the system.Then remove the cover over the rear unit.Then from under the vehicle remove the two a/c lines from the unit.Then remove mounting bolts and remove rear unit from vehicle.Then you remove the screws that hold the two halves of the case together.You will now see the expansion valve Use extreme care when removing the fittings from the valve.It is very easy to kink the copper lines.Reinstall in reverse order.Be sure to evacuate the system before recharging.

Posted on Aug 08, 2009

  • 70 Answers

SOURCE: my husband is putting 134a in my air conditioning

Recharge the system through the low side fitting, with the engine running you will need to have 25-30 psi on the low side gage, add freon a little at a time until this pressure is reached with the engine running and the compressor engaged.

Posted on May 30, 2010

duane_wong
  • 6826 Answers

SOURCE: air conditioning will not cool. I charged the

Make sure the pressure is 25 to 45 psi on the low side and that the pipes are getting cold on the low side.

Could be the vacuum controlled motors inside the dash.

Set climate control to hot then cold or the temperature control lever from hot to cold and listen for the vacuum motor operating the flap inside that changes the flow from the heater core to the evaporator inside the dash area.

Good luck to you.

Posted on Jul 05, 2010

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where do I add freon on a 1998 mercedez Benz


Nowhere...its called r-134a and you have to be a qualified technician to even deal with the stuff. There are air conditioning recharge kits you can buy...I assume this is what you have. Look for a valve on your air conditioning line that looks like a tire valve(shraeder valve) This is where you can add refrigerant...

Apr 05, 2014 | Cars & Trucks

1 Answer

Where is the freon tank


There isn't a tank, and it's not "freon". The refrigerant in your air conditioning system is either R-12 or R-134a, most likely. It's a compressed system that is in constant flow when the pump is operating, so if you need to add or charge refrigerant, you do it through the low-pressure port on the air conditioning lines. The recharge kit will only work on one of the fittings, so short of not using the kit properly, you can't mess it up.

Jun 27, 2010 | 1989 Mitsubishi Mirage

1 Answer

MY CAR'S AIR CONDITIONING ISN'T WORKING. MY SON


mcdevito75 here, either your son in law didn"t put in enough freon or the compressor is not working, Have your local shop check it out.

Jun 18, 2010 | 1998 Cadillac DeVille

1 Answer

Where do i add 134a coolant?


34A is freon so that will be connected to the liquid line to the Air conditioning hose which is the thinnest line towards the firewall

Jun 13, 2010 | 2000 Ford Expedition

1 Answer

Rear air condition is not working, only the front


No there is only one low and one high side service ports.You have a bad expansion valve on the rear a\c unit.To properly replace the valve,you must first recover the freon from the system.Then remove the cover over the rear unit.Then from under the vehicle remove the two a/c lines from the unit.Then remove mounting bolts and remove rear unit from vehicle.Then you remove the screws that hold the two halves of the case together.You will now see the expansion valve Use extreme care when removing the fittings from the valve.It is very easy to kink the copper lines.Reinstall in reverse order.Be sure to evacuate the system before recharging.

Aug 08, 2009 | 2003 Dodge Durango

1 Answer

2000 chevy tahoe air conditioning blowing warm air


probably a leak.

what are your high and low side pressures?

Aug 01, 2009 | 1996 Chevrolet Tahoe

1 Answer

Air conditioning system is not colling the car ? what do Ineed to do ?


i need to know how is not cooling the car?
is the fan blowing air or is the blowing air not cold?
it probably isnt cold.lets try that.
put a set of 134a ac gauges on the system and verify pressures.if it has low freon you may hear the compressor turning on and off.if so for sure its low and you will just need to add freon.
go get a 134a fron fill kit not the conversion kit.
and begin to fill untill the comp stays on and air is blowing cold.then stop filling and enjoy.
do not over fill as this will cause it to not cool again.

Jun 12, 2009 | 2002 Toyota Camry

1 Answer

Location of low pressure air conditioning port?


Follow the biggest a/c line from start to finish.Usually the a/c port is located near the firewall.I have seen the port located under the passenger wheel well.There should be a decal that states the type freon on or near the fan shroud,core support or on the under side of the hood.It is most likely to be type r-12.You can purchase an r-134a conversion kit. If you are not a/c certified to use r-12,you do not need certification for r-134a.

Aug 26, 2008 | 1990 Buick Regal

Not finding what you are looking for?
1996 Honda Accord Logo

Related Topics:

85 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

63990 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...