There should be a little canaster insid the dash maybe attach to the duct work it changes the position of the door if not it may be the control slide that you move to change the position of the heats function
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US. click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need. Goodluck!
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
sounds like you have a bad blend door motor that is stuck in the middle allowing for all vents to blow air... locate the motor under the dash and remove it. manually move the lever and see if it changes the flow.. check for power at that motor to make sure your getting the signal from the dash then you'll have found your problem....
Common question on this site. On late model cars, the vents are controlled by blend door motors. Small electric motors open and close doors to direct air flow. Chances are you have a blend door that is stuck or a failed motor. The default position is the defrost to make sure the windshield is always clear. Someone will need to look behind the dash to see if all of the doors will move on demand.
International 9400 9200 9900 heat box is under the passages side seat. That where the heater core location and the ac evaporator blower. You have two control motors under there one control the bunk for hot and cold. The other control front for hot and cold. Defrost vent and front vent is in the dash. My suck on defrost and in floor will open to front vent. I have not locate yet.
Chanses are its either the blend door motor quit working or the controls ( temp., selector, blower) in dash are bad, my 95 did the same thing i chg. the blend door motor thinking it was that, but it turned out to be the controls in the dash, 5 minutes work and 140.00 later it was fixed.
There is a vacuum leak under the hood. Find the vacuum line on the passenger side where it comes through the firewall and follow it to the engine. You system needs vacuum to operate and without it the default setting is on defrost for safety reasons.
Pull the AC control in the dash and verify that there is vacuum going to it, all the different air diversion doors are operated by seperate vacuum motors controlled by the ac control head in the dash, as you switch it it sends vacuum to the correct location to work that door for the desired air outlet, dash, floor etc..