Question about 1999 BMW 323 Series

1 Answer

I have a 84 mercuray grand marquis the brake pedal goes all the way to the floor its getting harder and harder to come to a complete stop.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 740 Answers

Bad master cylinder you may have a bad brake line/hose or leaking caliper/wheel cylinder . Check master cylinder to see if it filled if it is then there is NOT a leak and you have a bad MASTER CYLINDER. Change bleed and this should take care of this problem.Good luck nd thanks for using FIX YA

Posted on Mar 03, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

The engine surges on my 2007 when i step on the brake

If its only when you press the brakes, there may be a vacuum loss in the power brake system. Check the hoses from the manifold to the master cylinder booster or the connection on the booster itself. The hose may be split or the connection loose and leaking air. The booster itself may have a ruptured diaphragm. To check this, start the engine and run for a few minutes. Press the brake pedal and hold in. Turn off the engine. You should feel the brake pedal drop slightly. Remove your foot off the pedal and press the brake pedal a few times. Each time you press it , the pedal should keep dropping slightly and feel harder and harder to press. This will let you know that the booster is working properly.

Sep 17, 2015 | 2007 Mercury Grand Marquis LS

1 Answer

How to bleed brakes

That sounds more like a major leak or a bad master cylinder can you pump the brakes up to a hard pedal with the vehicle off?

Jun 11, 2015 | 1997 Mercury Grand Marquis

1 Answer

I have a 1997 jeep grand cherokee. I have no

got ABS
no, then bleed them.
read the manual yet the fsm.?
or any book on brakes?
click ZJ
click brakes

step by step
and skipping the MC bench bleed, will make this 100x harder.

Oct 04, 2014 | 1997 Jeep Grand Cherokee

2 Answers

Brake switch light location 1997 mrcury grand marquis

follow your brake pedal up, press it a little you will see where the switch makes contact with the pedal arm.

Apr 08, 2014 | 1997 Mercury Grand Marquis

1 Answer

Where is the fuse for my brake lights on a 1992 Mercury Grand Marquis

On the floor board you will find the brake pedal. The back side of the pedal hits a bake switch. follor it to the fuse box and replace.

Jun 20, 2010 | 1992 Mercury Grand Marquis

1 Answer

1993 Mercury Grand Marquis, Brake fluid leaking under left rear door. Brake pedal goes to floor. How can i fix this?

Hi, the reason the pedal goes to the floor is because the brake line going back to the rear axle blew, first you will need to find where the hole is and cut out the bad section, usually you can find a clean spot further down that you can cut out the bad spot. you will need to go to the parts store and get a new piece of brake line and a tubing cutter and a double flare kit. usually you can rent one of these to save money.

May 22, 2010 | 1991 Mercury Grand Marquis

2 Answers


Yes sounds like serious problem, especially the harder to stop, If you mean the car just isn't stopping as fast and included with the pedal getting closer to the floor sounds like you have a brake fluid leak. Might be leaking from a line maybe the master cylinder or caliper or wheel cylinder, any which way probably should get checked out.

Dec 03, 2009 | 1994 Buick LeSabre

1 Answer

Break peddle goes all the way to the floor

Fill the master cylinder with brake fluild unless its already full. f it was low or empty the system is leaking somewhere. If it's full it's a whole different story. You didn't say anything about warning lightsd on how long has it been this way and even thogh the pedal goes to the floor doesit still stop?

Oct 20, 2009 | 1995 Mercury Grand Marquis

2 Answers


check your brake booster vacuum pipe for leaks otherwise it sounds like your brake booster has failed

Jun 04, 2008 | 1986 Ford F150 SuperCab

Not finding what you are looking for?
1999 BMW 323 Series Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers


Level 2 Expert

254 Answers


Level 2 Expert

281 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides