Question about 1986 Nissan Pickup 4WD 1986

1 Answer

Need manual for 1986 nissan pickup 4cyl positive

Need manual for 1986 nissan pickup 4cyl positive cable routing from battery to starter

Posted by on

  • Anonymous Mar 17, 2014

    taillights will not go off on 1994 nissan pickup unless battery cables are disconnted

  • Anonymous Mar 17, 2014

    taillights will not go off on 1994 nissan pickup unless battery cables are disconnted



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Nissan Master
  • 2,105 Answers

Try here at AutoZone.

Posted on Mar 04, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I changed starter and battery and still wont start?

If you are saying the engine will not crank, you would need to check the circuit between the key switch and the starter.
There is a neutral safety switch in that circuit that could have failed.

Feb 13, 2013 | 1986 Nissan Pickup 4WD 1986

1 Answer

Every time i go to start up my 1986 toyota pick up it just makes a clicking noise i have to push start it every time i want to go some where.

I would start by checking the connections at the battery and make sure they are clean and tight. If the connections are tight and clean, replace the starter.
On some models with automatic transmission, it may be necessary to disconnect the throttle rod.
  1. Disconnect the negative (-) battery cable at the battery, then disconnect the positive (+) battery cable at the starter.
  2. Disconnect the remaining electrical connections at the starter solenoid.




May 07, 2011 | 1986 Toyota Pickup 4WD

1 Answer

Need a wiring diagram for 1986 ford mustang 4cyl engine. Helping a friend with his 4cylinder mustang and when i installed the negative terminal on the battery then as i place the positive terminal it...


You may have the positive cable hooked in the wrong side of the starting selenoid or the starter selenoid is defective.

Follow the RED (+) cable from the battery, it goes to the starter selenoid wich has two terminals, change the cable to the other terminal, that should take care of the problem unless the selenoid is stuck on. Replacement runs about $15.

Don't forget to rate this post. Good Luck!!

Jul 06, 2010 | 1986 Ford Mustang

1 Answer

How do you install a starter on a 1995 nissan Pick up? Remove the whole engine?

That shouldn't be necessary. - Disconnect the negative battery terminal first (always), then the positive. - Follow the positive lead to either the solenoid or the starter with solenoid; if the solenoid is not mounted on th starter, follow the cable leaving the solenoid to find the starter. - The starter should have sufficient clearance and is mounted at the junction of the transmission's bell housing and the engine block. - Disconnect the incoming cable from battery or solenoid.
They normally have only 2 or 3 bolts to remove and will then pull right out.
I recommend to anyone that they should have an aftermarket service manual if they intend to do any work on their vehicles and I like Haynes over Chilton. They recently dropped their prices $5 US to $20 and this is a real bargain if you get stuck:
1995 Nissan pickups
You might check your local library, they may have a donated copy to loan or eBay where you might also save a few dollars.

May 15, 2010 | 1995 Nissan Pickup

1 Answer


You probably already checked, but 1st thing to do is make sure the battery is good, fully charged, and cables are clean at connections, and tight. If so, Pull the starter out and bring it to a parts store where they will test it for free and let you know if it is shot. You can also remove it, attach jumper cables to it (neg. to metal body of starter, pos. to connection where battery cable was). Stand back as when you touch the pos. cable it will (if working properly) advance the gear on the shaft in the starter and then spin (to crank the engine over if it was mounted in place). This is a rather violent and very quick event, so stand back and be careful.

May 05, 2010 | 1986 Nissan Pickup 4WD 1986

1 Answer

Need the firing order digram for a 1996 nissan pickup 2.4 ltr

1996 Nissan/Datsun Truck Pickup 2WD 2.4L SFI 4cyl
The Firing Order:

Firing order 1-3-4-2 --------- front | | of | 1 2 3 4 | distributor rotates counter vehicle | | clockwise ---------

Hope helped with this (remember rated this help) Good luck.

Nov 04, 2009 | 1986 Nissan Pickup 4WD 1986

2 Answers

Nissan 1984 2.4l 4cyl. 8sparkplug timing?

For the 1984 Nissan Pickup (listed under 1986) 2.4L

Firing Order:
P.......Intake Side
l |.|
l |.|.....1......2......3......4
y......Exhaust Side

Distributor Connections:

Oct 31, 2009 | 1986 Nissan Pickup 4WD 1986

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

273 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

78267 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides