Question about 2001 Ford F250 Super Duty Super Cab

1 Answer

Minute mount 2 fisher plow stopped working up down side to side but the lights were on and the red light on the joy stick control went to a dim red and got brighter over a few minutes I checked out for a ground wire broken ,found nothing was told it could be the cylnode or the motor i changed both and still nothing then i jacked up blade to transport it to the shop and it started to work. sound crazy?

Posted by on

  • svienneau Mar 04, 2009

    Thanx, i'll take the armature out and look for any defects.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 51 Answers

There could be a flat spot in the motor that runs the blade

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a fisher minute mount 2 plow for some reason it only goes to the right now , not up or left , no matter what button I press on the control it goes right .


Start by plugging everything in and pop the cover off the control part on the plow and check for magnetism on all 3 solenoids when you hit the various buttons on your plow controller. The pull should be very strong and noticable...a weak magnetic pull is likely just residual magnetism on your screwdriver. In my case, the S3 solenoid wasn't firing and that causes exactly what you're describing.

If your S3 isn't firing you can test the wiring by moving the S3 hot wire to the S2 solenoid. If your wiring is good the plow will misbehave in an entirely different way. Also get out your ohm meter and test the S3, if its good you should get 7 ohms on it.

You need to use the guide from Fisher and be methodical about it. Start at the plow and work your way backwrds towards the truck.

Jan 27, 2016 | Cars & Trucks

1 Answer

I have a minute mount plow, when I try to use it only goes to left and right side but doesn't go up, when I try to lift the plow goes to the right. What can I do


2002 Fisher Minute Mount Inst-Act Wont Angle [Archive] - PlowSite ...

www.plowsite.com > ... > Truck & Equipment Repair

Nov 17, 2011 - 90 posts - ‎9 authors
My plow went up it was jerking and did it in steps , but , it got there . Now , it onlyjerks when i try to angle it right or left or up . I filled the fluid ... Drop it and if it doesn'traise you can just use a jack and shorten the transport chain to hold it. .... I do havecontinuity on the plow side for all 3 wires going to the plug . Hooking Up A Fisher Minute Mount 2 In Under 1 ...
54 posts
Feb 1, 2011
Plow Wont Angle
32 posts
Oct 19, 2010
What's wrong with my plow?
21 posts
Jan 9, 2003
Looking For Minute Mount Tips
57 posts
Feb 13, 2002
More results from www.plowsite.com

Ultramount Intermittent Angle Problem - Snow Plow Forum - L


Dec 27, 2015 | Cars & Trucks

2 Answers

I have a fisher minuteman plow it will go up, left and right but will not go down what is wrong with my plow


If you have a Minit Mount two it's probably the valve sticking. It's electronically controlled so if it clicks, then the solenoid is working and the shuttle in the valve is stuck. Can be disassembled and cleaned. New ones are best but pricey.

Jan 24, 2015 | Cars & Trucks

1 Answer

I have a fisher minute mount an older model with fixed controls. plow goes up and down but does not go left or right, sometimes with the control set for left or right it starts to go up ? where to sta


check the wiring connections on the plow solenoids to be sure they are correct, the second step is check the controller box, using a continuity check via multimeter set for DC voltage. I have an old western plow that had similar symptoms, and was the controller box.

Oct 19, 2014 | Cars & Trucks

1 Answer

Fisher minute mount plow


does the pressure release close to raise the plow?

Jan 05, 2014 | Dodge Cars & Trucks

1 Answer

Fisher minute mount 2 plow won't move.the motor runs but no plow movement? Is the pump bad?


You may have to bleed air out of the system to get it to work properly. Hope this helps.

Jan 02, 2014 | Cars & Trucks

1 Answer

Off/on light is flashing on HT handheld control and nothing is working on fisher plow but the headlights


You are in the wrong product section. Please find and post in correct category. Thanks and Merry Xmas!!

Dec 15, 2013 | Cars & Trucks

1 Answer

I have bought a minute mount 3 plug plow. The lights have power and are on. I try to the joy stick and the power clicks off on the stick. I tried to lift and angle the plow when the power on the stick...


It sounds like there is an in-line circuit breaker which is either defective, or not big enough or the motor is drawing too much amperage. Check with the manufacturer and ask the questions: what size circuit breaker should be used and what is the minimum wire size required. Check against what you actually have. You will probably find a wire hooked directly to the battery and the circuit breaker is usually located first in line close to the battery. Too small wire size could cause a fire.

Sep 22, 2010 | Chevrolet 1500 Cars & Trucks

3 Answers

I have a fisher minute mount and one headlight dim


A poor ground. Check the ground wire inside the light housing itself and then make sure it is getting a good ground where it mounts to the plow frame. Hope this helps.

Dec 05, 2009 | 2001 Dodge Ram 2500 Truck

Not finding what you are looking for?
2001 Ford F250 Super Duty Super Cab Logo

1,809 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...