Question about 2000 Ford Expedition

1 Answer

Electronic window mechanism froze up and disconnected inside the panel...motor works fine. How do I remove the panel and find a diagram to repair the mechanism?

Posted by on

  • Anonymous Mar 05, 2009

    the electric window mechanism became separated from the bottom of the door glass. with some epoxy, the glass tabs were glued to the glass. after a day the window worked fine till today when the glass separated again. how do i secure the glass into the two holders ???

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 106 Answers

Your repair manual for the vehicle should have a breakdown on how to remove/install the window regulator and motor.This is a comon problem on vehicles with electric windows.

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Driver window will not roll up or down....cables all wound up inside window motor...need schematic for window


What you need is a window regulator/motor assembly. Not a difficult repair. Two clips hold the window to the mechanism. Two bolts each for the tracks, and three bolts hold the motor to the inside panel of the door. Remove all these and the cable hold downs, fold together, and remove from inside the door. It is probably easier if you remove the glass after you remove the clips.

Aug 31, 2011 | 1996 Dodge Grand Caravan

2 Answers

How do I remove the left rear door panel from a 1996 Nissan Maxima? The window just fell down. It can be manually lifted up, but it slides back down again. It no longer mechanically works. If you can...



  • Disconnect the negative battery cable(for safety if you have power locks and windows)
  • At the bottom of the door panel remove the two screws
  • Pry up at the front edge of the power window switch pod and lift it out then unplug the electrical connector
  • Remove the inside door handle
  • Remove the screw in the door pull pocket
  • Pull the door panel away from the door far enough to disconnect the electrical connectors

May 23, 2011 | 1996 Nissan Maxima

1 Answer

02 Chevy Cavalier Coupe


there a screws holding the arm rest and on under the inside door handle. After that go around the perimeter of the panel and pull. There are numerous plastic press-bolts around the sides and bottom of the panel. The top lifts up off the door. Turn it around and take off the window connectors and lock connector. The motor is towards the bottom inside the door structure. Take the window out first. Be careful that you don't get pinched in teh mechanism. The motor is connected to the track system. It all should weasle out of the door then replace the motor.

Jul 26, 2010 | 2002 Chevrolet Cavalier Coupe

1 Answer

I think a part broke on my 2002 Mini Cooper's window lift mechan.


sounds like it window motor is weak has power to take it down just not the power to take it up

u really shouldent need a diagram window motor and regulator all one unit and usally pretty is to remove just remove door panel unbolt regulator from window
then eigher unbolt or grind or chishel rivits off door (some are held in by bolts some riveted in ) then remove asembley

Jun 03, 2010 | 2002 Mini Cooper

1 Answer

Drivers window goes up crooked and not closing properly 1998 buick park ave. motor works fine . going down is working proper.. going up is when the window goes up crooked. motor works very good


This can be 3 things wrong, either way the inside door trim panel has to be removed to inspect, 1} the glass has broken away from the glue holding it to the frame, 2} the mechanism has lost or has loose bolts holding it to the frame, 3} the mechanism is beyond economical repair and you need to replace the mechanism. Sorry I can't pinpoint it without seeing it, Remember to leave 4 thumbs up for this answer. We try to help as best we can, safe driving.

Jan 07, 2010 | 1998 Buick Park Avenue

1 Answer

Window went down on drivers side, the motor still works but something seems detached, what should i do?


On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Pull back the weather seal and you can readjust the window mechanics.

Sep 27, 2009 | 2002 Dodge Durango

1 Answer

I have a 1993 Ford Tempo and am having problems removing the motor from the door. I already have the door panel removed and the power disconnected from the motor.


remove the door panel and check to make sure the linkage to the lock assembly is still attached. I can't give an estimate because I don't know what is wrong at this point

are the locks manual or electric?i have seen most electric locks freeze up because of rust/.corrosion.the rubber accordian seal fails and moisture does it's job.there is no lubrication on the mechanism.it's basically a push pull magnet tube with a spiral grooved actuator rod.this is to assure no accidental vibration/jar induced movement.also means very difficult to budge when corroded.i have gotten a few to move by grabbing lock post with pliers and pulling hard.good luck!



Rear Door Window Regulator and Motor
Removal and Installation
Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Remove the door mounted speaker.
Remove the watershield.
NOTE:The glass must be lowered for this step.

NOTE:Some vehicles may use rivets to attach the glass to the regulator.

Remove the bolt that attaches the glass to the regulator.
Raise and support the rear door window glass to the full up position.

NOTE:Do not detach the door handle from the latch cable during this step.

Remove the rear inside door handle.
Remove the screw.
Disengage the inside door handle from the door.
If equipped, disconnect the power door lock rod from the back of the inside door handle.

Gain access to the power window motor electrical connector located in the front of the door.
Fig. 90: Identifying Power Window Motor Electrical Connector
Courtesy of FORD MOTOR CO.
Disconnect the power window motor electrical connector.
Press down on the connector tab.
Pull the connector upward and remove through the speaker opening in the door.
Disconnect the rear door window regulator and motor assembly from the door.
Remove the nuts.
Remove the screws.
Fig. 92: Disconnecting Rear Door Window Regulator And Motor Assembly From Door
Courtesy of FORD MOTOR CO.
266999_door_2.jpg
Remove the window regulator and motor assembly from the door.
Fig. 93: Removing Window Regulator And Motor Assembly From Door
Courtesy of FORD MOTOR CO.
266999_door_3.jpg

To install, reverse the removal procedure.

Jul 01, 2009 | Ford Tempo Cars & Trucks

1 Answer

2003 ford taurus drivers window will not go up.


you either need a motor or motor and window regulator assembly.
SECTION 501-05: Interior Trim and Ornamentation 2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION Front Door Trim Panel Removal and Installation
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the front door trim panel screws.
  1. NOTE: To release the door trim panel two part pin-type retainers, first pull outward on the bottom of the door trim panel.
    Remove the front door trim panel.
    • Disconnect the electrical connectors.
c64985a.gif --------------------------------------
SECTION 501-11: Glass, Frames and Mechanisms 2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION Front Door Window Regulator And Motor
Special Tool(s) s2h~us~en~file=st1132a.gif~gen~ref.gif Heavy Duty Riveter
501-D011 (D80L-23200-A) or equivalent
Removal and Installation
  1. Remove the front door window glass. For additional information, refer to Front Door Window Glass in this section.
  1. Disconnect the front door window regulator motor electrical connector.
  1. Remove the window regulator rivets.
-----------------------------
SECTION 501-11: Glass, Frames and Mechanisms 2002 Taurus/Sable Workshop Manual
REMOVAL AND INSTALLATION Door Window Regulator Motor Removal and Installation
  1. Close the window.
  1. Disconnect the battery ground cable. For additional information, refer to Section 414-01 .
  1. Remove the door trim panel. For additional information, refer to Section 501-05 .
  1. If equipped, remove the radio speaker.
  1. Position the watershield aside.
  1. Disconnect the door window regulator motor electrical connector.
  1. Remove the bolts and the door window regulator motor.
---------------------------------------------------

May 04, 2009 | Ford V6 Pony Cars & Trucks

2 Answers

Driver power window problem


On my 2000 Durango, I found that the plastic cable guides had broken and fallen to the bottom of the door. This allowed the cable to lose tension which basically disconnected the window from the regulator. If you can hear the regulator motor run (power windows) when you press the window switch, then the regulator is good. Remove the door trim panel screws, pull off the door lock handle, pull the trim panel away slightly, and disconnect the plastic retainer from the door latch linkage.Then unlock the wiring connectors and remove them. Now the trim panel can be removed. Peel the plastic seal from the inner door. Now you can see inside the door and figure out what happened. A mechanic's mirror will help. Replacement window regulators are available from a number of sources; the cable and/or guides are a dealer item.

Nov 12, 2008 | 2001 Dodge Durango

Not finding what you are looking for?
2000 Ford Expedition Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...