Iv'e replaced the sensor and cleared the fault on screen then it re appeared a few mins later
SOURCE: 2000 2.0 vw shutt down after running 20 min
Replace the fuel pump relay, it's easy and cheap.
SOURCE: Showing orange engine fault light on my Nissan Micra 2003
NISSAN HAD A RECALL ON THE CRANK AND CAM POSITION SENSORS. THEY ARE PLASTIC AND WHEN THEY GET HOT THEY CRACK, WHICH CAUSES OIL TO RUN INTO THE PLUG AND SHORT OUT. MY CARE STALLED AT 70 MPH WHEN MINE FAILED. NOT TOO HARD TO CHANGE. ONLY COAT ABOUT $40 AT AUTOZONE FOR NEW STYLE SENSOR (METAL INATEAD OF PLASTIC)
SOURCE: how to replace the crankshaft sensor on 2003 Nissan Altima
The cam sensor is mounted in top of the engine on the right side of the engine where the tranny mounts. You have to remove the top cover of the engine to get to it. Remove the electrical connector from the sensor, there is a clip that holds the connector in place. Push down on the back of it and then pull back at the same time. Pull on the connector and not the wires, they are very small and will break. Remove the bolt holding the sensor. To remove the sensor by twisting and pull on it at the same time. Is the engine not running, why are you replacing the cam sensor?
SOURCE: ABS FAULT WITH NISSAN TERRANO YREG
Had same fault - was damaged wiring in loom at back of engine where main engine harness meets the bulkhead.
There is a screened cable grey/pink that houses the two O/S/F ABS wires blue and pink. The loom copex cuts through the ABS cable causing this fault. Take a look at link below:
http://www.bba-reman.com/forums/Topic79424-1-1.aspx
611 views
Usually answered in minutes!
×