Question about 1986 Isuzu Trooper

3 Answers

1986 Isuzu Trooper 2.3 Gas Engine Running Too Fast

I just installed a new battery and water pump on my 1986 Isuzu Trooper and it runs at 3000 RPM with no throttle applied. It seems like a problem with the throttle shaft being misaligned or stuck. Can anyone help with this?

Posted by on

  • cphelps607 Mar 03, 2009

    This truck idled way too fast before the water pump and battery replacement. Just wanted to clarify that fact.

  • cphelps607 Mar 03, 2009

    I checked where the throttle cable hooks up to the throttle shaft. The mechanism does not seem to be held open by any adjustment screw. Is it possible that the throttle shaft is twisted internally in relation to the external linkage? Could there be two parts to the shaft that are now misaligned?

×

3 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check your throttle control module

Posted on Jul 26, 2012

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Bend your throttle bracket until it idles around 1000 rpms.

Posted on Mar 23, 2012

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 315 Answers

Follow the throttle cable to the throttle body, there should be an idle adjuster screw somewhere.

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Whats oil pressure on 3.1 isuzu


4psi idle (bad) and revving to 3k does what, you didnt say.
what was idle RPM 800 or 400>?
the answer is different by hot and cold oil
and oil type, no type stated (do not say brands) 10w30?
running 0w are you>?
and is as low as 8psi hot. at idle ,that is if idle speed is at spec.
is it?
and 3000 rpm would be like 25psi hot, and more cold.
the max pressure will be the pump regulator value.

here is the sensor spec.

The sensor closes when the oil pressure drops to between 4-7 psi (28-48 kPa).

the oil type and bearings clearances (in total) dictate pressure.

3,1 CPC engine spec is.


24649295-qvvdcm34jvcwbumk4o5kywm4-3-0.jpg

Jun 17, 2014 | 1994 Isuzu Trooper

1 Answer

1993 isuzu bighorn diesel engine holds revs to 3000 rpm for about 30 seconds and then dies


Do you think the primary fuel filter under the tank could be blocked or water is in the fuel?

Mar 25, 2014 | 1993 Isuzu Trooper

1 Answer

Engine is dying on idle


quick test , replace a piece of the fuel line with a clear plastic one, chaeck for air bubbles especially with less than half tank

Jul 28, 2010 | 1990 Isuzu Trooper

1 Answer

Would like to see diagram of 1986 isuzu trooper's engine


if it runs great...leave it alone and just maintain it, enjoy.

Nov 17, 2009 | 1986 Isuzu Trooper

1 Answer

I have a 2001 Isuzu Trooper and when I turn on the air conditioning the engine quits, what could be the problem?


AC pump seized up, or alternator not producing enough power to run it. Loose battery terminal connections or ground cable. Try turning the pump by hand when the engine is not running. You should be able to turn the end of it.

Jul 25, 2009 | 2001 Isuzu Trooper

1 Answer

88 isuzu trooper has trouble idleing


check fuel pressure, possible hole in fuel line in tank.
listen for spraying fuel while pump is running

Apr 21, 2009 | 1988 Isuzu Trooper 2 Door

1 Answer

Isuzu Tooper 1986, been sitting for 4 years, been thru 4 new pump


Checkmate. You have trash at the Bottom of that tank and will have to Drop it to stop Dropping Cash on Fuel Pumps and Injectors. There is not a lot of other Options that you have not Explored already.

Jan 12, 2009 | 1986 Isuzu Trooper

1 Answer

Will not idle at proper rpm


Try squeezing the fleixible fuel line before it gets into the fuel rail with the appropriate tool and see if the RPMs drop if they do either the pressure relief valve has failed or the fuel return line is blocked.Obviously you dont completely squeeze the line shut but only that you are taking some of the pressure out of the fuel rail allow enough fuel through to keep vehicle running.Its a cheap way to eliminate a potential cause for your problem.Excess pressure could be over powering the injectors.Are the injectors in a good servicable condition?

Nov 02, 2008 | 1988 Isuzu Trooper 2 Door

1 Answer

93 Trooper cranks, but won't turn over


have someone kick at the gas tank while you are turning key if it starts it is fuel pump

Aug 05, 2008 | 1993 Isuzu Trooper

Not finding what you are looking for?
Cars & Trucks Logo

553 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...