Question about 2000 Volkswagen Jetta TDI

1 Answer

I don't know what kind of oil pan I need for a 2000 volkswagon jetta 2.0 engine

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 41 Answers

The oil pan is aluminum and can be damaged easily. As far as i know, it is dealer part only. Check with your local part store and dealer for availibility. Also, the oil pan uses a sealant, not a gasket. If you repair it yourseslf and get parts from dealer, the whole tube of sealant is too much. If the whole tube is used, the oil pick up tube may get plugged.

Posted on Mar 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 VOLKSWAGEN JETTA automatic gasoline engine. shifts hard sometimes.


YOUR TRANSMISSION SOUND LIKE LOW IN TRANSMISSION FLUID. YOU HAVE A FACTORY SEAL TRANSMISSION IF SLIPPING SHIFTING HARD TRANSMISSION COULD HAVE FLUID LEAK. YOUR TRANSMISSION DONT HAVE OIL FILLER TUBE AND DIP STICK.THE VOLKSWAGON DEALERSHIP HAS TO USE EQUIPMENT TO ADD FLUID THROUGH TRANSMISSION FILLER PLUG ON UPPER SIDE TRANSMISSION PAN. IF TRANSMISSION FLUID HAS NEVER BEEN CHANGED LET DEALERSHIP CHANGE TRANSMISSION FLUID AND FILTER AND TRY TO LOCATE LEAK IF FLUID WAS LOW. ALSO MAKE SURE ENGINE FINE TUNED AND TRANSMISSION SHIFT CABLE ADJUSTMENT IS CORRECT.

Oct 18, 2011 | 2003 Volkswagen Jetta TDI

2 Answers

Volkswagon golf, my oil light comes on after an hour driving saying oil press......stop engine, had it in garage and they can find nothing wrong with it


Only two things:Change engine oil with recommended by the manufacturer depence of the mileage.Of course also oil filter.After that connect service oil pressure gauge to the engine oil truck and check the oil pressure.If OK change oil pressure sensor.

Jun 10, 2011 | 2000 Volkswagen GTI

1 Answer

Does a 2000 Mercury Cougar have any kind of sensor to keep it from locking up the engine when there is no oil? The oil pan busted while driving and engine shut off?


Some cars did have a fuel pump shut off if the oil was low, I don't know about the Cougar. You didn't cook the engine did you? It will run about 2 or 3 mins without oil. Then it is cooked. And how did the oil pan break?? Check it out.

Oct 21, 2010 | 2000 Mercury Cougar

1 Answer

Changing a sump on Jetta IV


You need VW silicone sealant D 176 404 A2.
  • Apply 2 to 3mm (1/8") bead of new sealant to oil pan sealing surface. Be sure to run bead on the inside of the bolt holes.
  • Immediately install oil pan to cylinder block and loosely install M7 bolts diagonally.
  • Install and lightly tighten M10 bolts securing oil pan to transmission.
  • Diagonally tighten M7 oil pan bolt further, but not final torque.
  • Diagonally torque M7 bolts securing oil pan to cylinder block.
  • Oil pan to transmission (M10)... 45 Nm(33 ft-lb)
  • Oil pan to cylinder block (M7)...15 Nm(11 ft-lb)
  • Wait 30 minutes as prescribed and refill with proper viscosity and quantity of engine oil.

Apr 20, 2010 | 2002 Volkswagen Jetta TDI

1 Answer

Which plug drains the oil


It's on the bottom of the engine. You'll see the oil pan (smooth, rounded edges) and the drain plug on one of the bottom edges. Problem is, you need to remove several T20 torx fasteners and the car's belly pan to access the oil drain bolt (should be 19mm wrench) on the Jetta.

Nov 04, 2009 | 2000 Volkswagen Jetta TDI

4 Answers

Location of crank sensor 1998 jetta 2.0


It's located near the cam gear on the front of the engine however, the crank sensor, to the right of the oil filter near the bell housing is the part notorious for going out on these cars, and causing a p0322 and/or p0341 code, and sometimes others as well To replace the crank sensor you have to: Support the motor with a floor jack. Remove the starter, 2 of the starter bolts connect to the motor mount. Remove the motor mount from the frame, very easy. Remove the oil filter. That will give you just enough room to get an allen wrench in to remove the bolt holding the sensor in.

Oct 25, 2009 | 1998 Volkswagen Jetta

2 Answers

Help i need a new oil pan


Here is some great PRINTER solution by Some FIXYA EXPERT.
Get any kinds of PRINTER solution from bellow.
7

Oct 03, 2009 | 2004 Volkswagen Jetta

1 Answer

What type of transmission fluid can i use for a 1996 volkswagon jetta


bye it from the dealer its syntectic oil that goes in it or go to autopart store there some castrol oil for volk but go to the dealer ask for what kind of oil goes in it thanks pierre

Mar 04, 2009 | 1996 Volkswagen Jetta

1 Answer

Oil drain 2007 volkswagon jetta 2.5 sedan


on the bottom of the oil pan is a bolt you have to take off.

Jan 06, 2009 | 2007 Volkswagen Jetta 2.5 Sedan

Not finding what you are looking for?
2000 Volkswagen Jetta TDI Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21927 Answers

yadayada
yadayada

Level 3 Expert

60541 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...