Question about 2003 Chevrolet Suburban 1500

2 Answers

Turn signals do not work - 2003 Chevrolet Suburban 1500

Posted by on

  • bensisko06 Mar 03, 2009

    hello thanks for the reply I've replace the flasher the brake light switch and the turn signal switch and as soon as i step on the brake light pedal or turn on the turn signal the fuse blows

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Chevrolet Master
  • 60,769 Answers

Replace the turn signal flasher done so already let me know

Posted on Mar 03, 2009

  • yadayada
    yadayada Mar 03, 2009

    do u have any trailer wiring that has been wired into your system?

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 6,784 Answers

Hi there, i would first check the fuse box for a blown fuse. secondly, i would check the relay for issues. last, i would check the actual wand or switch for lose connections and bad switch assembly. the issue will be in one or both of the areas stated.

Posted on Mar 03, 2009

  • Michael Masters
    Michael Masters Mar 03, 2009

    Ok, make sure the wires aren't crossed. i would retrace all steps to make sure that a ground is not attached to a positive strand. normally when the fuse is blown, its because of a crossed wiring issue. make sure every step of the wiring process is correct.

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Brake light trouble right side brake light will not come on but both flashers work also turn signals work older ford truck what could the problem


I have to think the problem is inside the turn signal switch, a poor internal connection. You know the brake signal first goes through the turn switch before it goes to the bulbs. That is why the brake lights and rear turn signal lights share the same filament in the bulb, and the same wire going to those lights. The only difference is the turning side light is affected by the turn signal flasher, causing blinking, while the other side- the non turning side-does not go through the flasher relay, but straight to the bulb from the turn signal switch. Change your turn signal switch and I believe you will solve the problem. Let me know, okay?

Sep 16, 2015 | Ford Cars & Trucks

1 Answer

Left turn signal will not work


either wrong signal bulb or short in left turn signal wiring if both left signal lamps not working.if only one of left turn signal dont work could have corroded bulb socket spray a little electronic cleaner in bulb sockets see if left signal work.

Nov 27, 2011 | Cars & Trucks

2 Answers

95' Buick regal, 3rd brake light works, tail lights work, turn signals work, stoplight switch seems to work ie 3rd brake light working, fuse is ok, changed bulbs, but no rear brake lights.


If the third brake light works and the regular ones don't, it is most likely a bad turn signal (multifunction) switch. The switch is able to kill the brakes lights to run the turn signals, and in rare circumstances does this. I've seen it several times. It could also be wiring, especially near the turn signal switch, but it is usually the switch.

Nov 25, 2009 | 1995 Buick Regal

1 Answer

1997 Chevy Tahoe both turn signals stopped working


Sounds like the flasher unit to me. Normally the emergency flasher and turn signal are separate.

Jul 21, 2009 | 2001 Chevrolet Tahoe

1 Answer

Turn signal lights stop working. Neither the right or left turn signal work. Heard a noise before it stop working. The flashing started slowing down and stop blinking. Now it doesn't work at all. What


most likely its the turn signal relay. which is under the hood. in the fuse box. also make sure ur running lights are working if they are connected to the turn signal.

May 08, 2009 | 1993 Nissan Pathfinder

3 Answers

1997 dodge avenger turn signal probs and location


replace the turn signal switch it self, mine did the same thing with the left turn signal, put in fuse and it will continue to flash... went to junk yard pulled one out of a 97 avenger just like mine, swapped them out and now it works fine. looked to be like some corrosion... to repace: 3 screws under columb, 2 screws on side of signal switch (black plastic side). unplug and replace

Mar 20, 2009 | 1997 Dodge Avenger

1 Answer

Turn signal problems


Turn signals have a relay (its a small switch that charges and discharges current) which controls your turn signals blinking speed and interval. This is most likely your problem. You should be able to get a new one at your local parts store. Follow these instructions, in this order, and let me know how it works.

Step 1:Turn on the hazard lights and walk around the Taurus checking that all four turn signal lights are working. If any of them are not working, replace the bulbs. A non-working bulb in any of the turn signals will often make the turn signals appear that a flasher is going bad.

Step 2:
Locate the fuse box and check the fuses for the turn signals. There may be more than one. Replace any fuses that are blown and then recheck the turn signals again. If they still aren't working properly, then move on to replace the flasher. Step 3: Look for a round, silver-colored object near the fuse box. Put your finger on the object and turn on the turn signal. You should be able to feel a mechanical clicking as the turn signal blinks. This is the flasher. Step 4: Pull the silver flasher out of the socket and replace it with the new one. Each of the flashers should have two pins sticking out of the bottom side. Start the Taurus and recheck the turn signals to ensure that they work. Joel

Mar 04, 2009 | 1999 Ford Taurus

3 Answers

Turn signals


replaced turn signal flashers and muti switch turn signal still won't work Why?

Nov 08, 2008 | 2000 Jeep Grand Cherokee

1 Answer

Turn signal


Now replace the flasher unit! Frankster016

Oct 25, 2008 | 2002 Nissan Xterra

Not finding what you are looking for?
2003 Chevrolet Suburban 1500 Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60769 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...