Question about 2005 Jeep Liberty

1 Answer

Can not remove the clutch pedel switch .has some type of keeper on the pedel i can not remove.

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 4 Answers

I believe that the switch just needs to be rotated 45* and slid out. Not a hard removal :)

Posted on Mar 30, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I bought a new slave cylinder for a 1998 pontiac sun came with a rolled pin and a slave cylinder in on the inside of my transmission,i dont know what the pin are the keeper is for.

Here's a link on doing the job,the extra parts as you stated may be needed. Repair Guides Clutch Actuator slave Cylinder AutoZone com Here's another link on removing the transaxle,I look at Autozone's part and Advance auto parts and one has the pin and keeper and other shows just the keeper. Repair Guides Manual Transaxle Manual Transaxle Assembly AutoZone com looked at Oriellys and it has the same part as autozone.

Aug 26, 2016 | 1998 Pontiac Sunfire

1 Answer

My brake light switch is broken

Its on the brake pedel you need to remove a clip from the end of the pin that slides through the pedel and the brake switch then the pin then the connecter . Install in reverse order .
However before removeing anything you should look to see if there is an adjustment for the switch . You see the brake light olny comes on if you push on the pedel most have adjustments on them because its an on demand thing so the light could be on if your not pushing the pedel or it could not come if you are pushing the pedel or it could not come on at all pushing or not pushing to pedel .You need to figure witch condution you actully have .

Mar 15, 2015 | Cars & Trucks

1 Answer

How to remove the starter disabler

Is it a manule ? if so the switch is by the top of the clutch pedel,

Sep 27, 2013 | 1998 Toyota Corolla

3 Answers

You have to hold the clutch pedel in just the right place before it will start

Pretty obvious

Adjust or replace clutch switch,if it
is tested, and found to be worn

Mar 22, 2011 | 1996 Chevrolet S-10 Pickup

2 Answers

Clutch switch has been giving problem for awhile and now it won't start at all. How do I check this problem and fix it?

un hook or( unplug i should say) the clutch switch and jump the wires , now mind you clutch will not have to be depressed now so make sure vehicle is not in gear. If it starts then your clutch switch was bad

Jan 16, 2011 | 1990 Ford F150

2 Answers

Brake light fails to go off, when truck is off

Eighter the brake light switch is sticking or its no good . The switch controls the rear brake lights thats all it dose. But its easy and eary inexpensive to replace. Look up under the dashboard at the top of the brake pedel you will see a switch that if you push on the pedel it pushes a plunger into the switch . Its like a light switch in your house its on or off . The switch can be checked with a meter that has an OMHS setting with out removeing it by unpluging the connector from the switch take two jump leads clip one to each side of the switch terminals then clip the probes from the meter to the leads from the meter it dosn't witch side then push the pedel it should read 0 with no pressure and read 100 % with pressure so its on or off as long as it is on one way and off the other way its good . If its no good there is a clip on one side of a pin that slides thruogh the pedel and the switch remove this clip slide the pin out the switch will pop off there will likely be a bushing that is in the assembly and mabey a couple of washers note how they come out when your removeing the switch Then reassemble in oppistte order There will also be some type of adjustment on the plunger a small nut on a threaded rod look to see where it contacts its stop and adjust acordly

Jan 12, 2011 | 1995 Nissan Pickup

1 Answer

My hyundai sonata 1999 model cannot start but their is light in the dashboard what will i do to fix the problem

have you depressed the clutch pedel sonatas have an interlock that prevent starting until the clutch pedel is pressed in if this does not fix the problem and the battery is fully charged trace the wiring from the clutch pedel to confirm its not brocken

Nov 12, 2010 | 1999 Hyundai Sonata

1 Answer

I have a rattling sound when i ever i dip my clutch pedel

sounds like the shock springs on the clutch friction plate,nothing to worry about unless it judders....

Jun 15, 2010 | 2002 Jaguar X-Type

1 Answer

Clutch keeps coming out

if you mean the clutch doesnt engage until the pedel is nearly all the way out (up) .. then there is an adjustment for that called "free pedel adjustment" .. its usually a 5 min job .. however if there is any clutch chatter or noise then you may need a new clutch plate ... a bigger job ... one way to burn up the clutch plate is to allow it to slip for a long time ... and thats what will happen if the free pedel adjustment isnt done soon ... if your problem is not that then maybe you can expain more ....

Apr 15, 2010 | 1991 Volkswagen Jetta

1 Answer

S Type JAguar Rear Door

First remove all of the screws, some will be hidden under plastic caps, then take a door panel tool (about $5.00 at a parts store) and work it around the panel popping out the plastic keepers. Be carefull and try not to damage the panel where the keepers attach, you can buy new keepers at any auto part store and even Lowe's and Home Depot carry them.

Jul 18, 2009 | 2000 Jaguar S-Type

Not finding what you are looking for?
2005 Jeep Liberty Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides