Battery light My battery is new and the battery light went on while drving. What's the problem?

Remove the oil sender unit and fit a pressure gauge , start the engine and check pressure, seems odd the oil light and pressure gauge both showed a fault at the same time, perhaps the oil pump relief valve stuck open for a short time.

PO115 code, Has to do with the tempature cooling sensor, Install a new one,

This NO BUS means your PCM aka main computer is not communicating with your instrument cluster. It could be bad, but first make sure your gauges work, then try removing cables from battery for 30 mins and reconnecting. If that doesn't work, it may need a new computer PCM.

Thinking you have a pass lock problem. In the ignition key and tumbler,
all I can do is send you to the dealer ,watch the security light,it's actions will help diagnose the
trouble . My money is on the Ign. switch

do you have an engine light on? might be a loose battery connection.

check your battery cables

Look under the hood and see if the big belt is still on the pulleys. When you said it will not start back up does that mean it will crank over?

If everything is dead take your battery in to check it or charge it. If the battery is good and charged see what works and doesn't. Like lights, windows, locks, seats and write it down.

If the motor cranks, go into the trunk and press a button for 3 seconds. It is in a cutout in the carpet and it is the Inertia safety switch. It is usually close to the air ride switch. Then try starting.

Take to Autozone or another parts store and ask them to scan your car.

do you know what the code is if so email me at napashawn@gmail.com

yes... bad ground to battery...rain has exacerbated it... check/charge /replace battery..test charging system and have all battery connections..especially ground cleaned and tightened ..good luck

I have a similar type of problem. After charging the battery and re-setting the computer, the front and rear lights that would be on in the drving light mode, now are somehow connected to a flasher unit and continue to flash even when the key is off. The only way I've found to stop the lights flashing is to pull the green fuse in the computer box. Looks forward to learning how to fix.