Question about 1997 Jaguar XJ6

1 Answer

Engine misfire Just had engine on my XJ sport 3.2i steam cleaned and now have a misfire, will it clear itself.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Hi,
I solved the problem by undoing all the HT leads and found water at the bottom, once I had blown the water out and dried up all around I reinserted the leads, tightened everything up, and prblem solved.

Posted on Mar 03, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 97 jep cherokee country 4.0 and can't find the fuel filter...my jeep acts like it's not getting.gas and wants to put? when im going 60 or so and i changed the fuel pump but its still doing it


if you follow the fuel rail gas line, it goes to the filter.
for sure.
4.0L 97 , we have the FSM to see all that , ive posted it 100s of times here. that link.
please explain the bog more clearly.
cold or hot engine or both.?
is it just tip-in throttle bogging , only then POWER catches, up?
while bogging can you go to WOT and see if it has full power now?
ever get a full 60k mile tune up with new spark parts. and filters.
is engine misfiring.
is engine idle too low rpm or too high with a hot engine?
is fuel old.
did car sit for long time ? unused?

"not getting gas" can be 2 things, bogging or misfiring
they are night and day different, one is like pulling a dead weight
the misfire is violent engine shaking,
see?
and 2 different diagnostic paths due to that ...

if wot is ok, then that implies fuel pressure is good. and filter.
see?

WOT = WIDE OPEN THROTTLE.
i drove a 99 XJ for 300k miles. and know it well..

free fsm
click fuel system here 96-2001 xj
http://www.jeep4x4center.com/knowledge-base/index.htm?utm_source=cj#service

see that page? page 14 in PDF
if you changed the pump, you had it in your hand.
unknowing
its on top of the fuel tank pump RACK.

if engine is tuned up,?
and power is low at wot,
i check fuel pressure live.(under varying engine loads)
if the pressure is out of spec, i get a new filter and PPR.
if pressures are in spec. dynamically.
i find out why the PCM is under-injecting.
ask how. its not hard.
(bad MAP?, , injector balance tests?)

Jul 16, 2015 | Jeep Cars & Trucks

2 Answers

So I have an 2002 mazda protege and not long after putting in a new stereo and cleaning the car and the engine My car started shaking and having a hard time accelerating I did a diagnostic test on it cause...


Check the spark plug for Cylinder #3. Check the boot and wire around that plug and back to the distributor/coil. Likely have water (from washing your engine) arcing and shorting that cylinder & causing misfire. Wait for a long time for everything to dry, should clear itself. Also, hope you used MAF sensor cleaner to clean the MAF sensor. If you used something else, you might have ruined the sensor - it is very delicate.

Apr 20, 2014 | Cars & Trucks

1 Answer

2004 xj vanden plas. Check engine light came on. Obd read as p0193 and p1111. Need help. Ty


p0193 sounds like a ip sensor circuit malfunction the p1111 is system check has been completed p1000 system check is not completed..that number will check from 1000 to 1111 when the car has ran a complete self check of itself.

Apr 05, 2014 | 2004 Jaguar XJ-Series

1 Answer

Jaguar xj sport 3.2 no spark or injector pulse


If ECU has crank signal and engine turns over, ECU should give injectors a pulse and trigger the ignition. If not ECU might be bad. You should check power and grounds going to ECU. There are usually multiple power and grounds going into ECU

Jan 06, 2014 | Cars & Trucks

1 Answer

Suzuki aerio


is running rich. that cutting out is called misfire.
in this case, rich caused misfiring.
Does the CEL lamp come on? Check engine lamp.
misfire is complex. (caused my many a thing and needs careful
diagnosis by a technician)

May 13, 2013 | 2002 Suzuki Aerio

1 Answer

Check engine light on restricted performance amber light on my 02 jag xj


What codes do you have?

Get the codes,look them up &
have a repair start over & resolve,
unless you can handle the fix

It is either in fail safe for overheating,ignition misfires
or trans problems

Nov 22, 2012 | 1996 Jaguar Xj Series

1 Answer

I steam clean my motor today then change the oil,spark plugs& flushed the cooling system,the car ran great for the first 20 miles then it lost power and the engine died it took a while to get it...


YES,you steam cleaned the engine,it may right itself after drying out(hopefully)when you steam clean, the water particles are much smaller than a normal "hose down"so you may have wet the electronics.if it starts, then let it run for awhile to (hopefully)dry out itself.

Oct 01, 2010 | 2001 Pontiac Sunfire

2 Answers

I washed my 1990 toyota camrys engine and now it stalls when u drive it but no problem starting


If you steam-cleaned, the vapor seeps into the electrical components and causes problems.

The advice folks hear around the repair shops is: 'Never steam-clean an engine'

If you hosed it down, the stalling may clear up pretty soon.

Oct 12, 2009 | 1990 Toyota Camry

1 Answer

DTS-P 1404(EGR Valve)


unhook the battery for ten minutes and hook it back up... that will clear the code... if your stereo requires a code make sure you know it first.

Robert

Please take a moment to rate this solution thanks

Feb 09, 2009 | 2001 Buick LeSabre

1 Answer

'88 XJ-S Misfiring When Warmed Up


have you tried a new coolant sensor?it is poss it is telling the ecu its still cold so its chucking more fuel through. also get a block tester and test cylinder head

Dec 13, 2008 | 1986 Jaguar XJSC

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

147 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

yadayada
yadayada

Level 3 Expert

70387 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

447 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...