Question about 1999 Mazda 626

1 Answer

When i put the foot on the gas hard it starts to judder.

When i put the foot on the gas hard it starts to splutter and judder.sounds like it backfires.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

I had a similar problem with a 626 some years ago ,i replaced the H.T leads and this cured the problem hope this is of use to you

Posted on Mar 07, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Why does my 1994 2.0 GT celica sound like its splutter/ misfiring mainly when I put the foot down

Not enough fuel. Could be fuel filter, fuel pressure, fuel pressure regulator(or vacuum to it), or clogged injectors. Could just need a tune up.

Feb 27, 2016 | Cars & Trucks

1 Answer

I have T5 2.5 turbo Drive for about 5 minutesthen it starts to judder between 1500 to 1800 rpm gets worse on light throtle .put foot on throttle or back off and judder goes away then ASR light comes on...

you may have a bad turbo it is common on the vw. with engine off take off big black tube and see if filled up with oil. if has alot of oil it in it will need to be replaced.
did the cam code come back on or was this a old code stored in memory?

Jan 06, 2012 | Volkswagen Transporter Cars & Trucks

1 Answer

A few weeks ago my astra 2001 started to splutter and the carbon emmissions orange light came on,it stayed on for abt a week then went off,then a few weeks later it happened again then went off so i put it...

First start to check for fuel pressure. It sounds like you have a bum fuel fuel pump. Have some one turn the key and someone else listen nearest the tank to see if they can hear it turn on. Let me know what you find.

Jul 20, 2011 | Fiat 124 Cars & Trucks

1 Answer

Hi I've got a rx8 192, the other night i turned the key ok this bit is my fault but i never held the key long enough so had to turn the key for a second time but this time the car started but it...

Thanks for choosing FixYa and welcome. Usually a flashing light like yours means the engine has internal damage. Now that it is not doing that, all I could think of is the ECM felt like it was necessary to flash the check engine light. It could be many things, from plugs and wires to ignition calculations. The best thing to do is have your car put on a diagnostic machine. If the check engine light comes back on, take it to Autozone or Advanced asap to have it tested for error codes. The timing belt/chain may have slipped. You could have bad spark plugs/coils. These usually result in backfire. Without the proper testing, it is hard to determine a starting point. Check all your hoses and electrical wires for damage and check all your fuses. When you can, get it put on the machine.

Jun 03, 2011 | 2005 Mazda RX-8

1 Answer

My 04 1.6 renault megane struggles to start in th morning and once it does fire up you hav to rev it to ensure it wont cut out. The car then splutters and judders a bit till its warm then it tend to run...

My 05 1.6 renault megane struggles to start in th morning and once it does fire up you hav to rev it to ensure it wont cut out. The car then splutters and judders a bit till its warm then it tend to run ok. but keeps on switching off at the robots when i stop please what could it be

Sep 30, 2010 | 2003 Renault 181

2 Answers

RenaultClio 1.5dci juddering when started if it was going stall

These type of engines have direct rail injection so each cylinder has an injector. The problem sounds like the engine is only running on 3 cylinders (or less). It could be a faulty injector. Are you losing coolant? Is it overheating? Is there steam or excessive smoke coming out of the exhaust tail pipe?

Apr 08, 2009 | 2005 Renault 181

1 Answer

Juddering and knocking sound on my two year old Ford S Max

did you use the glowplugs? before starting they may be bad.

Mar 07, 2009 | Ford F-450 Cars & Trucks

1 Answer

XJS V12, 1986. Loses power and splutters on hard acceleration

Most probably is the crank sensor under engine worn out. )0 % trobleshut starts here.
Einar Norway

Sep 27, 2008 | 1986 Jaguar XJSC

Not finding what you are looking for?
1999 Mazda 626 Logo

Related Topics:

184 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

70347 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6876 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides