Question about 2004 Chevrolet TrailBlazer

1 Answer

Vibration from fan

My belt started squeaking, we changed it then the water pump went out, we put a new one on, then the clutch fan was wobbling then we replaced that, but now the fan itself seems to be warped. My car vibrates. What else can we do?

Posted by on

  • 2 more comments 
  • cityofmelbou Mar 02, 2009

    we just put a new clutch fan on. Not the actual fan itself

  • cityofmelbou Mar 02, 2009

    I guess you can say we just put the clutch on and not a new fan. Could this be my problem. What could have warped the fan?

  • cityofmelbou Mar 02, 2009

    Thanks I will check it out.

  • ccn7 May 11, 2010

    Did you just put a clutch on the old fan blade? or did you chg. both?

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 6,982 Answers

Make sure that you have everything you installed flush with mounting surfaces. Are all of the fan blades intact? Unless something bent the fan (unusual) it should be good, but if you need to, get another from a junkyard and try it!

Posted on Mar 02, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can I replace the fan clutch on a 2005 colorado with reg fan blade


Let the vehicle run at approx 2000 rpm (standing still) and check the heatgauge. When the needle gets near the max mark you sould be able to feel the fan blowing air. Switch off the vehicle and feel if the fan is solid or not. You can use a standard blade, will have very small effect on feul consumption and power.

Jun 25, 2012 | 2005 Chevrolet Colorado

2 Answers

2002 Ford Mustang pulley squealing


Replace the crank pulley before it costs you an arm and a leg. It has caused this problem. don-ohio

Mar 26, 2017 | Ford Cars & Trucks

1 Answer

I have a 1997 dakota 5.2 motor. Had to replace fan blade & clutch. Im putting a new water pump on now. if i still have noise what other things should i check.


Alternator, A/C Compressor, Power-steering pump, smog pump, idler pully(s).

I would pull the belt(s) and check each pulley for wobble or rough spinning.

Hope this helps

Feb 23, 2011 | 1997 Dodge Dakota

2 Answers

Bearing has collapsed,fan is wobbling and unstable


Yes you must remove the timing belt and gear to remove the water pump. I always recommend a new timing belt as part of the repair. Regards, Joe
PS kindly rate my answer. Thank you.

Jan 20, 2010 | 1991 Toyota Land Cruiser

1 Answer

1988 jeep cherokee, 4.0. newer water pump *few months maybe* doesnt over heat, no leak, but it squeaks, just like a bad idler pulley would. when running i sprayed oil in on it and it stop squeaking for a...


Take the belt off check the clutch fan and spin all the pullies insure they spin freely and do not wobble if any do replace them if all checks out ok put a new belt on. make sure the belt tension is not to tight should have about 3/4 inch play.

Oct 05, 2009 | 1988 Jeep Cherokee

1 Answer

Water Pump Leaking


the hardest part of this job is removing your fan clutch. you removed your top fan shroud, then your fan clutch, its reverse thread. take off your belt, upper radiator hose and 6 10mm bolts hold it in. clean water pump housing and put all back together. aftermarket water pumps do not come with theermostat, dealer pumps do. remove your belt tensioner from old water pump 3- 15mm bolt, two different sizes and install on your new pump. you need, 10mm socket, 15mm socket, flat head screw driver, pliers to removed hose,fan clutch tool(rent at autoparts store)

May 05, 2009 | 2000 Chevrolet Suburban

1 Answer

Squeaking noise front drivers side of engine


Loosen the belts [ you do not need to remove] so they are free of tension to all pulleys.Start engine , if noise goes away either belts were too loose [ common on lx 450] or you have a worn & noisey pulley /bearing.have seen idler pulley below alternator have dry / noisey bearing.Otherwise if idler is ok it has to be another belt driven assessory , ac clutch,water pump & or fan clutch.Good Luck.

Jan 17, 2009 | 1997 Lexus LX 450

Not finding what you are looking for?
2004 Chevrolet TrailBlazer Logo

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

70346 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6864 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...