Question about 1984 Ford F 150

1 Answer

Cylinoid installation I needed help on installing a new cylinoid on my 84 pickup. instructions would be great

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

Starter Solenoid? It's not hard, unhook the battery and bolt it on. If you need to, draw a diagram of the wiring on a piece of paper to aid you in the install.

Posted on Mar 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

84 nissan carburetor two wheel drive nissan pickup will not idle down


Hi Shane ,just answered your carb problem,here is the weber carb i installed,call me if you like.Click here to see. 85 Nissan 720 4x4 2 4 Weber conversion Here's another to see. 85 Nissan 720 4x4 Silverbullet 4 with Samantha YORKIE at the wheel look out

Apr 07, 2015 | 1984 Nissan Pickup

1 Answer

Where is relay? RY71T is part # for 84 ford f150


LOOK IT UP ON LINE. RY71T FIR 84 FIRD F150 MANUAL

Feb 03, 2015 | 1984 Ford F 150

1 Answer

How to install a starter on a 1999 Mitsubishi Galant?


Welcome to Fixya

Please see procedure below for removal and installation of the starter:

Disconnect the battery, and make sure the engine is cold when doing this because you will be working underneath the exhaust pipes. Using 8mm socket remove the bolts holding the small guard separating the starter from the exhaust. Using a 12mm socket remove the nut on the front (closest to you) part of the cylinoid on top of the starter. Using 14mm socket remove the two bolts holding the starter on to the engine. Take the old starter off, then place the new starter on and following these instructions in reverse order.

Thank you for using Fixya!

Mar 26, 2011 | Mitsubishi Galant Cars & Trucks

1 Answer

I put a new alternater in and as soon as I start it up the alternater fails. Alternater is installed properly and belt is installed properly but still fails. 84 toyota pickup 22r engine


check an see if you have a alt fuse blown it takes a little juice to the alt to make it put out juice what im saying is get a text light an see if you have power going to the alt its called an exiter wire you haft to exited the alt to get it started haha hope this helped

Dec 16, 2010 | 1984 Toyota 4Runner

1 Answer

Oil pump ,,,where is the oil pump located on a 1997 dodge caravan


Hello
Welcome!
Oil pump is located on the oil pan.
Parts needed,,,oil,,,, oil filter,,,, oil pan gasket,,, oil pump,,,, oil pump pickup tube..
time to do this,, about 3 hours
Instructions,
Raise van place on 2 jack stands
drain oil remove oil filter fill new filter install.
remove bolts from oil pan,
remove oil pan..
remove 2 bolts that hold oil pump and tube.

install new pump and tube tork bolts to 45 fp
replace oil pan gasket and install oil pan
tork pan bolts to 35" pounds
install drain plug
fill with oil
start and check for leaks

let me know if i can help more

Jul 17, 2010 | 1997 Dodge Caravan

1 Answer

1984 s10 2.8 manual trans. flywheel causes engine to vibrate


no should be same engine. check your engine mounts and tranny mount. how bad a vibration? sometimes after installing engine the trans gets shifted around and if mount was worn it will allow it to hit crossmeber and vibrate.

Jan 16, 2009 | 1984 Chevrolet S-10

1 Answer

84 Nissan Pickup 24z


Burnt wires going into alternator

Dec 15, 2008 | 1984 Nissan Pickup

1 Answer

Won't start


Check your alternator, it may have gone bad and its draining your battery.

Dec 07, 2008 | 1994 Plymouth Sundance

2 Answers

84 S-10 V6 Pickup will not stay running


I have an 84 S-10 that had the same problem. Mine would die when I made a left turn. I had to replace the fuel pump and have not had that problem ever again. If you have a mechanical fuel pump that is located on the engine block, you can go to Auto Zone and get one cheap. If you have an electronic pump I would shop around to find the best price.

Nov 24, 2008 | 1984 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Fordexpert

Level 3 Expert

5331 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...