Question about 1998 Mercury Mystique

2 Answers

Mercury mystique starter location

2000 mercury mystique starter location, were is it?

Posted by on

  • Anonymous Mar 26, 2014

    need to know what size torque bit to remove belt tensioner

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

  • Contributor
  • 1 Answer

Its a 6 I beleive its a 2.5

Posted on Mar 24, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 4,669 Answers

4 or 6 cylinder

Posted on Mar 02, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace starter in 2000 mercury mystique V6 2.5?


http://www.ehow.com/how_8217220_install-2000-ford-contour-v6.html
couldn't find your exact model, but this is the procedure for that motor.

Feb 27, 2013 | 1998 Mercury Mystique

2 Answers

My starter went out on my 2000 mercury mystique and my husband wants to change it hisself, but he needs a diagram to do it. can anyone help me out here?


When he goes to the auto parts store he will purchase a rebuilt starter that will come with instructions. Once he has swapped the new for the old, he will return the old to the auto parts store as part of the deal. Joe

Mar 02, 2010 | 2000 Mercury Mystique

1 Answer

How to install 2000 Mercury Mystique trunk strut?


The temp sending sensor is located under thermostat housing assy.
you will need to detatch upper radiator hose detatch 3 thermostat housing bolts to remove the housing just enough to remove the clip holding the sensor . detatch elect. connector.
: don't misplace thermostat housing seal inside housing.
very easy job !

Jan 26, 2010 | 2000 Mercury Mystique

1 Answer

My 2000 mercury Mystique wont start when i turn the key in the ignition is just clicks what could it be alternator starter or battery?


first check battery voltage. should be 12 volts or a little over. IF the battery is low then charge battery and then load test battery. If you remove you battery and take it to local parts store most will check for you. if battery load test good but was low on voltage then I would check to see that alternator is charging while engine is running. should be charging aprox 13.9 volts. if battery had full voltage and load tested good then most likely the starter is bad.

Jan 16, 2010 | 2000 Mercury Mystique

1 Answer

I have a 2000 Mercury Mystique IT is not wanting to start once I get it started it runs fine but it is getting harder to start


if it seems to be turning over slower than you remember, when it was easy to start . the bushings in the starter are probably worn allowing the armature to make contact
with the field coils in the starter case.
this then causes a severe amperage draw on the battery,which in turn drops the voltage to computer and ignition circuit below 12 volts while cranking

Nov 12, 2009 | 2000 Mercury Mystique

1 Answer

Fuse for Cigarette lighter


http://www.genuineservice.com/genuineservice/en/default?page=genuineService

Go to the website above. Pick owner guide on left task bar. Input vehicle info then pick get owner guide.
Pick owner guide 1st printing and fuse info begins on page 144

Apr 13, 2009 | 2000 Mercury Mystique

Not finding what you are looking for?
1998 Mercury Mystique Logo

Related Topics:

914 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

61037 Answers

Fordexpert

Level 3 Expert

5331 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...